Minka 2754-694 Bulb Lighting Instructions
- June 2, 2024
- MINKA
Table of Contents
Minka 2754-694 Bulb Lighting
READ AND SAVE THESE INSTRUCTIONS
WAR N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E AK E R AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig. 1)
- Fig. 1
- Set# A-010
- -Crossbar
- -Ground screw
- *-Mounting screw2**
- Chain#HCH2072-761
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove old fixture, including mounting hardware.
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Align the holes on metal arm (C) to fixture body (D) and secure with screws (B)
-
Secure pine cones (A) to the metal sticks on metal arms (C).
-
HANGING THE FIXTURE (Fig. 2)
-
Thread all thread into ceiling loop until snug.
-
Thread the other end of all thread into the crossbar.
Note: The length of all thread into the crossbar may be adjusted if necessary. -
Use lock washer and hex nut to secure all thread to crossbar.
-
Take this crossbar assembly and mount it to junction box (not included) with mounting screws (Size: #8-32N*L0.5”). The side of crossbar marked with “GND” must face out.
-
Determine the desired hanging height and use a pair of proper chain pliers to remove and discard the excess chain.
-
Open one end of chain and attach it to fixture loop then close the chain. Slip the lock collar and canopy over the chain and allow them to rest on the fixture body. Open the other end of the chain and attach it to ceiling loop then close the chain.
-
Carefully lace fixture’s wires through chain. Feed fixture wires through ceiling loop and crossbar assembly.
CONNECTING THE WIRE (Fig. 3)
-
Connect the electrical wire as shown in figure 3, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the crossbar using the green screw provided.
-
Tuck these wire connections neatly into junction box. Slide canopy over canopy loop and secure with lock collar.
FINISHING THE FIXTURE (Fig.1) -
14. Place small glass shade (F) over socket (E) and secure with socket ring (G) using socket spanner (H).
-
Install (4) four medium base bulbs (I) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!). -
Place large glass shade (J) over socket (E) and twist to secure it to the socket cup.
Your installation is now complete. Return power to the outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
- Notice: It is important to use proper chain pliers (not included) To OPEN and CLOSE the chain included with this fixture. Do not open them with other tools that may twist or stress the chain links. It is important to use proper chain pliers like the ones shown in the diagram.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>