WASSERSTEIN 4895230304402 Horizontal Angle Mount User Manual
- June 3, 2024
- WASSERSTEIN
Table of Contents
WASSERSTEIN 4895230304402 Horizontal Angle Mount
In the Box
Compatibility
Google Nest Doorbell (Wired, 2nd Gen)
Pre-Installation
- We recommend that you use a magnetic screwdriver.
- Do not install the tiny screw to lock the Horizontal Angle Mount before mounting it to the wall.
Installation
-
Turn off the power of your doorbell at the electrical panel.
Note : Always consult a professional electrician before working with electrical wires. -
If a doorbell was previously installed on your wall, take it down and disconnect the wires
-
Open up and carefully pull apart the wedge and wall plate.
-
Feed the wires through the cutout. Attach the mount to the wall using the long screws and wall anchors provided (drill bit size: 1/8 in).
Note : To install in the opposite direction, simply flip it over before mounting -
Reattach the wedge. Press together firmly until it clicks into place
-
Mount the doorbell backplate to the wedge with the short screws provided.
-
Connect the wires to the doorbell. Then, attach the doorbell to the wedge and lock it by securing it with the screw that came with your doorbell.
-
Set your doorbell to your preferred angle and tighten the tiny screws on the top and bottom of the mount.
-
Turn on the power and check the Google Home App to make sure the mount and doorbell have been installed properly.
Get More Support
Scan the QR code below or email us at contact@wasserstein- home.com.
This product has been certified by Wasserstein to meet Google’s compatibility standards. Google is not responsible for the operation of this product or its compliance with any applicable safety or other requirements. Learn more at g.co/madeforgoogle. Google’s “made for” badge, Google Nest Cam, and related marks are trademarks of Google LLC.
www.wasserstein-home.com Hergestellt in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>