baby trend TS44XXXD EZ Ride Plus Travel System Instruction Manual

baby trend TS44XXXD EZ Ride Plus Travel System

WARRANTY
DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT
BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.

The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.

Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty
for complete warranty details.

WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.
WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and insure that the children are properly positioned according to these instructions.
WARNING: Never leave children unattended.
WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

• CAUTION: This stroller is designed for one child only. Use with more than one child may cause the unbalance condition which can injure/ harm your child.

• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.

• The maximum weight that can be carried in the storage basket is 5 lb
  (2.27 kg). The maximum weight that can be carried in the Parent Tray and Child Tray is 3 lb (1.36 kg) each. Excessive weight may cause a hazardous unstable condition to exist.

• Be certain the stroller is completely opened and locked in place before allowing a child near the stroller.

• The maximum weight capacity of this stroller is up to 50 pounds (22.62 kg) or 40 inches (101.6 cm), additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist.

• NEVER use the stroller on stairways or escalators.

• NEVER use the stroller with roller skates, in-line skates, skateboards or bicycles.

• NEVER allow your stroller to be used as a toy.

• To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.

• Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.

• Discontinue use of stroller should it malfunction or become damaged.
  Please contact our customer service department to arrange for repair or obtain replacement parts.

BABY TREND® CUSTOMER SERVICE
The Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.

PARTS

Check that you have all the parts for this model before assembling the stroller.*Please refer to the manual located under the car seat for base type and instructions.

ASSEMBLY

IMPORTANT! To ensure safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.
IMPORTANT! Adult assembly is required.

The front wheels, rear wheels, child tray, and parent tray MUST be installed prior to use.

FRONT WHEELS

• Release the fold latch by pulling it outward (Fig. 1a).

• Unfold stroller frame by pulling backward on the stroller handle (Fig. 1b).

• “Remove and discard” the cap on the front wheel hub.
  NOTE: May require to grip the cap tightly and pull out with force to remove completely (Fig. 1c

• To attach the front wheels, lean the stroller back so that it rests on the handle with the front and rear legs pointing upward. Position the front wheels over the front leg tubes so that the hole in the housing lines up and will slide onto the legs (Fig. 1d). Firmly push down until the wheels
  lock securely into place.
  NOTE: Pull on the wheel assembly to ensure that it is securely attached to the stroller.

REAR WHEELS

• Position axle assembly over the rear leg tubes, brake pedals facing the back. At the same time, push down applying equal pressure to both sides until they lock into place (Fig. 2).

NOTE: NEVER use stroller if wheels do not lock into place. If you need assistance, please contact our customer service department at 1-800-328-7363, M-F, between 8am and 4:30pm, PST.

CHILD TRAY

• To attach the child tray: push the angled side of the tray onto  the post at the end of the right armrest while pressing downward on the snap button, until locking in place (Fig. 3a). Rotate the tray downward until it latches onto the left armrest into place (Fig. 3b).

NOTE: Check that the snap button comes through and securely in place (Fig. 3c).

• To access the child seat: Press tray release button and rotate upward on the tray (Fig. 3d).

CANOPY

• To install the canopy, slide the male ends of the canopy into the female slots on the stroller frame (Fig. 4a).
• Hook and loop both fasteners of the canopy fabric onto the frameon both sides (Fig. 4b)

NOTE: Assemble the parent tray to before using this feature. Refer to step 5.

• To open the canopy: push forward on the front edge of the canopy (Fig. 4c). To use the visor flip outward
  (Fig. 4d).

• To fold the canopy: pull backwards on the front edge (Fig. 4c).

MOBILE PHONE POSITIONING PARENT TRAY

WARNING: Do not place hot liquids or more than 3 lb (1.36 kg) in the parent tray. Serious burns
or unstable conditions can result.
WARNING: Care must be taken when folding stroller to prevent damage.
Make sure all accessories, mobile phones, diaper bags or purses are removed before folding. Failure to remove items in, or on the
stroller may result in damage to the stroller or the item (s) if not removed. Baby Trend® will not be liable or warrant any damage.

• Before Attaching The Tray:

1. Face the tray with the prominent arch side towards the canopy. Locate the six attachment straps (Fig. 5a).
2. Flip tray over with slots facing towards the seat and canopy (Fig. 5b).  

NOTE: Pairing the straps of the seat and canopy together is required (Fig. 5c).

3. Pair the straps and insert into the tray slots (Fig. 5d).
4. Align both straps with the designated tab and fasten in place (Fig. 5e).
5. Flip the tray over and align the parent tray tabs to the inner tabs on both sides of the stroller. Press the tray down firmly until both tabs click into position (Fig. 5f). 

• To adjust the canopy: Adjust the canopy hook and loop fasteners on each side of the stroller frame (Fig. 5g).

• Mobile phone positioner: Align mobile phone to the clip and insert it through the grips. Make sure to push the phone all the way down into the positioner (Fig. 5h).
  NOTE: The positioner may not accommodate all mobile phones or other devices. Do not use positioner as a secure holder when stroller is not in use or if your phone is loose or is too large.

MULTI-POSITION HANDLE

• To adjust the handle, press the buttons to move the handle up or down to a comfort position for the user (Fig. 6).

BASKET

• Rear basket tube needs to be installed prior to use. Insert the female end of the rear basket tube into the male ends located on the basket frame until it locks into place (Fig. 7).

BRAKES

WARNING: Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave stroller unattended on a hill or incline as the stroller may slide down the hill.

• To engage brakes, apply light downward pressure to the brake lever located on each rear wheel. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster (Fig. 8).
  NOTE: Check that the stroller will not move and that both brakes are properly applied.

• To release, gently lift up on the brake lever (Fig. 8).

SAFETY SEGURIDAD

TO SECURE THE CHILD

WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.
STRANGULATION HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone.

• Snap the side of seat pad onto the inner sides of the frame (Fig. 9a). Repeat for the other side.

• The shoulder straps of the 5-point harness have 3 attachment positions.
  Select the position that places the shoulder strap level with, or below the top of the child’s shoulder. To adjust harness height unhook the shoulder strap from the crotch buckle (Fig. 9b).

• Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat underneath the fabric.
  Feed shoulder strap through appropriate slot and reattach shoulder strap to crotch buckle (Fig. 9c).

• Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders (Fig. 9d).

• Push Button on Center Clasp, the two Harness Buckles will pop free (Fig. 10).

SEAT BACK POSITION

WARNING: The upright position should be used only for a child that is at least 6 months old.
WARNING: Never use seat in a reclined carriage position unless enclosure is raised to cover the front opening. Child may slip into leg openings
and strangle..

• To recline the seat press the clip ends together to release and pull down. To place seat into an upright position, press the clip ends together while holding the end of strap. Push clip upwards to secure into desired position (Fig. 11). The upright position should be used only for a child that is at least 6 months old. Always re-adjust the safety harness, including the shoulder belts, when repositioning the seatback.

INFANT CAR SEAT

INFANT CAR SEAT ATTACHMENT

WARNING: Avoid serious injury from falling or sliding out, always use the Infant Car Seat harness.

ATTENTION: CS01 EZ-Lift, CS02 EZ-Lift PLUS and CS03 EZ-Lift PRO Infant Car Seats must attach to the module of the strollers front seat. These models require child tray and seat back adjustment to the most reclined position.
NOTE: To make seat position adjustments refer to step 11.

CS01 EZ-Lift, CS02 EZ-Lift PLUS and
CS03 EZ-Lift PRO Infant Car Seats

CAR SEATS MODULE CONNECTION

• From the rear side of the stroller engage both car seat support tabs (Fig. 12a).

• Align the car seat module to the inner frame connectors Carefully lower into the stroller to latch in the car seat. Press down firmly for the click. ALWAYS ensure that the car seat is properly connected and locked onto the stroller before each use by lifting up on the car seat handle (Fig. 12b).

• NOTE: To make seat position adjustments refer to step 11.

REMOVING THE CAR SEAT:

• NOTE: Set handle to the carry position (Fig. 13a). Squeeze the release handle located at the Top-rear of the car seat and lift away from the stroller (Fig. 13b).

NOTE: To attach the head pillow and bottom inserts, refer to the CS02 instruction manual.

OTHER COMPATIBLE CAR SEATS OTROS

• Put the stroller seat in the full recline position, See (Fig. 11). Turn car seat support tabs on
  the stroller frame (Fig. 14a). Car Seat Support Tabs are Only used for the infant car seat. Check that the front child tray is firmly attached to the stroller armrests.

• Position the infant car seat so that it faces toward the rear of the stroller. Push the car seat into the front tray until it latches into place (Fig. 14b). The rear of the car seat rests on the support tabs. Put the stroller seat in the most upright position for additional support (Fig. 11).

• When the infant car seat is locked firmly into place, secure the single short clip over the infant car seat through the belt path on the infant car seat (Fig. 14c).
  It is very important that the short clip is always tightly fastened around the infant car seat.
  Always secure your child with the car seat harness when using the car seat in the stroller.
  If your child is already in the car seat, check that the child is secured with the harness.
  Improper use of the stroller with the car seat may result in serious injury or death.

Removing the car seat from the child tray:

•  First use the carry handle buttons to rotate it to the carry position (Fig. 14d). Remove the short clip from the infant car seat (Fig. 14e).

• To remove the Infant Car Seat, squeeze the release handle located at the Top-rear of the seat and carefully lift upward on the seat (Fig. 14f). From the rear side of the stroller disengage both car seat support tabs (Fig. 14g).

FOLD / UNFOLD

TO FOLD STROLLER

WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

CAUTION: Do not allow children near stroller while folding.

• To fold the stroller slide the thumb trigger to the left and squeeze the pull trigger while pushing forward on the handle (Fig. 15a).
• Once the stroller begins to fold, release the handle and push forward on the handle until the stroller is folded (Fig. 15b). Use the fold latch to secure the stroller (Fig. 15c).

CAUTION: Do not allow children near stroller while unfolding.

• Release the fold latch (Fig. 16a) and unfold stroller frame by pulling upward on the stroller handle until the frame locks (Fig. 16b).

MAINTENANCE

SEAT PAD

• To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

OTHER

• Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed

FRONT WHEEL – MAINTENANCE

• If replacing the front wheel, press the pin located behind the wheel hub. Pull the wheel out from the hub (Fig. 17).

REAR WHEEL – MAINTENANCE

• If replacing the rear axle, press the pin on each side behind the wheel hub. Pull the rear axle out from the hub (Fig. 18).

CANOPY / PARENT TRAY – MAINTENANCE

• Removal: Under the stroller frame locate the parent tray tabs. Press them inwards and lift up the tray from the housing (Fig 19). To detach both tray and. canopy reverse steps 4 through 5.

References

• Limited Warranty Coverage – Baby Trend
• Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>