baby trend BT05 Series Second Toddler Seat for Morph Single to Double Stroller Instruction Manual

BT05 Series Second Toddler Seat for Morph Single to Double Stroller
Instruction Manual

Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.

WARRANTY

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.
Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.
Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.
Baby Trend, Inc. 13048 Valley Blvd. Fontana CA 92335
1-800-328-7363
(8:00am ~ 4:30pm PST)
www.babytrend.com

WARNING
WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.
WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and insure that the children are properly positioned according to these instructions.
WARNING: Child may slip into leg openings and strangle. NEVER use in full recline position unless the seat is in full recline and footrest buckle released.
WARNING: Care must be taken when assembling and disassembling the product onto the stroller to prevent finger entrapment.
Follow all the instruction and warning for TS11/ST11 to ensure the safety of your children.

• The Seat is designed for a child who is at least 6 months and is not over 40 inches (102 cm) tall. Max. weight 50 pounds (22.67 kg).
• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition. Adding an extra parcel bag or parcel rack will render the stroller unstable.

The Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.

ADDITIONAL ACCESSORIES **

**

Check that you have all the parts for this model before assembling to the stroller.

Toddler Seat is only compatible with Morph Single Double Modular Travel System (TS11).
For stroller instruction manual and compatibility chart (visit babytrend.com).

1. ASSEMBLING THE TODDLER SEAT
   Unfold the toddler seat fully (Fig. 1a).To assemble the toddler seat, unzip the zipper fully, located underneath the seat (Fig. 1b). Unwrap the fabric from the tube (Fig. 1c). (1) Push the lower tubes into the inner slot of the seat frame. (2) Ensure the push pin clicks into place on both sides. Then wrap the fabric back, and zip the zipper around the sea frame. If received unattached, follow below instructions to attach:
   Feed the strap through the tab to anchor the seat fabric on the seat frame, ensure the toddler seat is secured (Fig. 1d). Repeat for the other side.
   Ensure the stroller adapters are positioned on the middle level.
   Attach the seat by lining up the seat anchors on the side of the seat with the anchors on the stroller frame and pushing them together until they click securely (Fig. 1e). The seat can face in either direction, frontward or backward. Carriage Mode
   Make sure the buckle strap underneath the seat is unbuckled. Then loosen the recline seat strap by squeezing the adjuster and pulling downwards (Fig. 1f). The carriage should be fully extended before using. NOTE: The footrest area should be unbuckled (Fig. 1g).

2. BUMPER BAR HANDLE COVER
   To attach: Before attaching the bumper bar to the stroller, wrap the handle cover around the bar (Fig. 2a).

3. BUMPER BAR
   WARNING: Do not use bumper bar to lift or carry seat with child inside. The bumper bar is not a carrying handle.
   WARNING-FALL HAZARD: Bumper bar is not designed to support a car seat, stroller may become unstable.
   Attach the bumper bar by lining up anchors with the slots on the seat. Push until it locks into place (Fig. 3a).
   NOTE: The bumper bar must be securely attached before using this product.
   To detach the bumper bar, press the release button on the bottom of the bar on each side, and pull bar out of the anchors (Fig. 3b).

4. TO ADJUST SEAT
   WARNING: The upright position should be used only for a child that is at least 6 months old.
   Toddler Seat Mode: The seat can be adjusted into an upright, reclined position. Push the center button on both sides of the stroller adapter to rotate the seat (Fig. 4a). Rotate the seat into the desired position until it clicks into place (Fig. 4b). The seat can face in either direction, frontward or backward. Buckle the strap located underneath the seat (Fig. 4c). To tighten the strap, use the hook and loop method through the clip. Pull the strap firmly and attach.
   To adjust the recline seat strap, squeeze the adjuster while pulling downwards or upwards (Fig. 4d). Note: There are 6 positions for the leg-rest. Press on both sides to unlock, adjust to desired position and release the buttons to lock into position (Fig. 14e).

5. REMOVABLE CANOPY
   To attach the removable canopy: Slide the canopy clips on the inside of the corresponding slots on the stroller frame (Fig. 5a).Pull over the back of the canopy fabric to connect the three attachments located on the top of the seat frame (Fig. 5b).
   To open the canopy: Push forward on the front edge of the canopy while holding the rear of canopy in place (Fig. 5c). To fold the canopy: Pull backwards on the front edge (Fig. 5d).
   To remove the canopy: Press inward on both canopy tabs and slide the canopy up to remove (Fig. 5e).

6. TO SECURE THE CHILD
   WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.
   STRANGULATION HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone.
   Type 1
   The shoulder straps of the 5-point harness have 3 attachment positions. Select the position that places the shoulder strap level with, or below the top of the child’s shoulder (Fig. 6a). To adjust harness height unhook the shoulder strap from the crotch buckle. Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat underneath the fabric. Feed shoulder strap through the appropriate slot and reattach the shoulder strap to the crotch buckle. Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the child’s shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness so it is snug around the child’s waist and over the child’s shoulders (Fig. 6b). TO RELEASE THE CHILD
   Type 1
   To release, push the button on center clasp and the two harness buckles will pop free (Fig. 6c).Unhook the shoulder straps only if adjusting the harness positions (Fig. 6d).

7. DISASSEMBLE THE SEAT
   NOTE: The stroller can be folded with or without the seat installed.
   Before folding the stroller, push the lower buttons on each side of the seat to disengage from the stroller frame (Fig. 7). DO NOT remove with child in the stroller seat.

WARNING! These are the ONLY approved use modes. Failure to follow these instructions could result in serious injury or death.

DOUBLE RIDING POSITIONS

Toddler Seat, Bassinet Modes:

1. Toddler Seat – High Position – Forward Facing, Toddler Seat – Low Position – Forward Facing
2. Toddler Seat – High Position – Forward Facing, Toddler Seat – Low Position – Rear Facing
3. Toddler Seat – High Position – Rear Facing, Toddler Seat – Low Position – Forward Facing
4. Toddler Seat – High Position – Rear Facing, Toddler Seat – Low Position – Rear Facing
5. Carriage – High Position – Forward Facing, Carriage – Low Position – Rear Facing
6. Carriage – High Position – Rear Facing, Carriage – Low Position – Rear Facing

MAINTENANCE AND CLEANING

• SEAT PAD: To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.
• BUMPER BAR AND TODDLER SEAT FRAME: Wipe clean with soft, clean cloth and mild soap.
• OTHER: Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace o repair parts as needed.

Baby Trend, Inc.
13048 Valley Blvd.
Fontana CA 92335
1-800-328-7363
(8:00 a.m. ~ 4:30 p.m. PST)
www.babytrend.com
Copyright © 2023, Baby Trend Inc., All Rights Reserved.

References

• Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!
• Limited Warranty Coverage – Baby Trend
• #1 in Cloud Security & Endpoint Cybersecurity | Trend Micro
• Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>