TESLA TSL-SEN-BUTTON Smart Sensor Button User Manual
- June 3, 2024
- Tesla
Table of Contents
TESLA SMART
SENSOR BUTTON
USER MANUAL
Product Description
Linkage Setting (Detail please refer to APP)
- Single click
- Double click
- Long press (LED off after 3s, release the button)
Network Setting
1. Power on the product.
Insert a thin blade or coin into the slot on the battery cover and rotate it anticlockwise to open the battery cover.
Remove the battery insulation film to power on the product and close the
battery cover.
2. Press the reset button for 5S and release, the red LED will flash f or
network setting.
Use a pin to press the button for 5s.
Network Setting Note:
Press the reset button for 5s-10s, the red LED is on for 5s then turns off,
release the reset button for network setting. During network setting, LED
keeps on flashing for 20s. If pressing for more than 10s, network setting
cancelled The red LED will be on for 5s to indicate network setting succeeds.
If fails, the red LED is off.
Installation Instructions
Method 1: Directly place the product in the target position.
Method 2: Remove the protective film from the adhesive and attach the product to the target position.
Technical Parameters
| Wireless Technology | ZigBee |
|---|---|
| Working Voltage | DC 3 V (CR 2032 battery) |
| Transmission Frequency | 2.4 GHz |
| Working Temperature | -10°C to +55°C |
| Undervoltage Alarm | supported |
| Dimensions | Ø 50 mm x 16 mm |
INFORMATION ABOUT DISPOSAL AND RECYCLING
This product is marked with the symbol for separate collection. The product
must be disposed of in accordance with the regulations for disposal of
electrical and electronic equipment (Directive 2012/19/EU on waste electrical
and electronic equipment). Disposal together with regular municipal waste is
prohibited. Dispose of all electrical and electronic products in accordance
with all local and European regulations at the designated collection points
which hold the appropriate authorisation and certification in line with the
local and legislative regulations. Correct disposal and recycling help to
minimise impacts on the environment and human health. Further information
regarding disposal can be obtained from the vendor, authorised service centre
or local authorities.
EU DECLARATION OF CONFORMITY
Hereby, Tesla Global Limited declares that the radio equipment type TSL-SEN-
BUTTON is in compliance with EU directives. The full text of the EU
declaration of conformity is available at the following internet address:
tsl.sh/doc
Connectivity: Wi-Fi 2,4 GHz IEEE 802.11b/g/n
Frequency band: 2.412 – 2.472 MHz
Max. radio-frequency power (EIRP): < 20 dBm
Manufacturer
Tesla Global Limited
Far East Consortium Building, 121 Des Voeux Road Central Hong Kong
www.teslasmart.com TESLA SMART
SENSOR BUTTON
Documents / Resources
|
TESLA TSL-SEN-BUTTON Smart Sensor
Button
[pdf] User Manual
TSL-SEN-BUTTON Smart Sensor Button, TSL-SEN-BUTTON, Smart Sensor Button,
Sensor Button, Button
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>