Galaxy Equipment 177GLXYGW Electric Bar Glass Washer User Manual
- June 3, 2024
- Galaxy Equipment
Table of Contents
Galaxy Equipment 177GLXYGW Electric Bar Glass Washer
Please read and keep these instructions. Indoor use only.
Important Safety Information
When using electrical appliances, basic safety precautions should always be followed, including the following:
- Read all instructions carefully and completely.
- For commercial use only.
- Do not touch hot surfaces.
- The motor is water-resistant, but not entirely submersible. Never fill the water higher than the fill line indicated on the unit. Do not put this product in sinks or tanks where there is a risk of falling over or submersing the motor.
- Unplug this unit when not in use and before cleaning.
- Allow the unit to cool before putting on or taking off parts.
- Do not operate this or any appliance with a damaged electrical cord or plug.
- Do not operate this or any appliance after it has malfunctioned or been damaged in any way.
- Do not use outdoors.
- Do not place it on or near a hot gas or electric burner.
- Disconnect the unit by turning the power switch to “OFF”, then removing the electrical plug from the wall outlet.
- Do not use the appliance for any application other than for intended use.
- Do not cover or wrap the motor of this unit when in operation.
- Do not allow this glass washer to touch or be covered by flammable material, such as curtains, draperies, walls, etc., when in operation.
- Do not clean with metal scouring pads as pieces can break off and touch electrical components, heightening the risk of electrical shock.
- Do not cover the exterior of this unit with metal foil as it may cause the glass washer to overheat.
- Avoid scratching the surface or nicking the edges of this unit. Do not put the slim or sharp articles beyond the unit.
- Turn the appliance off by turning the power switch button to the “OFF” position.
- Note that the use of accessories not recommended by the manufacturer may result in injury.
- Children should be supervised to ensure that they do not play with the glass washer.
- This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- When using the appliance in shops, snack bars, hotels, etc., check the voltage and outlet to make sure the appliance is correctly connected to power.
- Install the unit on a sink with a flat surface that is well-ventilated.
NOTE: Save these instructions for future reference.
Identification Of Parts
- Power Switch
- Power Cord
- Motor
- Exterior Tube
- Supporting Board
- Foot
- Small Brush
- Big Brush
Circuit Diagram
Before Using Your Glass Washer
Before using your glass washer, please follow these simple instructions.
Failing to do so may cause injury to the user and damage the machine.
- Install the machine on a flat surface of a sink and make sure the machine is upright and stable.
- Assemble the brushes and check that they are securely in place.
- Pour water into the sink and observe that the water level does not exceed the water line mark on the exterior tube.
- Add some detergent for washing.
- Plug the power cord incorrectly.
WARNING: Do not overfill the sinks/tanks or fully submerse the glass
washer motor.
WARNING: Plug the unit into grounded outlets only that match the unit’s
voltage and frequency listed on the motor. The outlet must be UL/CSA and
G.F.C.I.
WARNING: Check the electric cord and plug to make sure it is clean and
dry before using. Keep the power cord away from the brushes and water. Never
use the machine if the power cord is cracked or damaged.
WARNING: The SWITCH must NOT contact the water, keep it dry.
CAUTION: Check and make sure the brushes are securely in place before
turning on the machine.
CAUTION: Do NOT use the machine for any other purpose than its intended
design.
Using Your Glass Washer
To start the glass washer, plug in the power cord and switch on the machine.
When the brushes start to spin, put the glass on top of the brush to wash. It
is recommended to wash one glass at a time for the best results.
WARNING: Do not operate the machine out of water.
WARNING: Keep the machine upright. Do not use it if it is lying down.
WARNING: Motor may get hot during and after operation; turn it off when
it’s not in use.
Typical Operation Sequence
Action Result
__
Plug in your glass washer
| Power is connected, but unit will only start after the machine is switched
on
__
Switch On
| __
Unit starts to work; brushes start to spin
__
Place glass over the brush
| __
The glass is cleaned
__
Switch Off
| __
Unit stops working
__
Unplug the unit
| __
No power is connected
Protection Component
This glasswasher includes a capacitor motor. To protect the electronic
components inside, the
the machine will shut off automatically if it begins to overheat.
Cleaning & Maintaining Your Glass Washer
To clean, first, remove the power cord’s plug from the wall outlet. Wait for
the glass washer to cool down. Use a damp cloth or sponge to gently wipe down
the unit. Avoid soaking the whole unit in water or washing it in running water
as this will cause serious damage to the unit. When closing for the day, drain
the sink and wipe off the machine, and let the machine dry overnight. After
use for a month, remove the base cover that protects the gears inside. Immerse
the machine in the water, and add 1/2 cup of vinegar. Operate the machine for
10 minutes, rinse thoroughly, and replace the base cover.
Specifications
Model #| Volt / Frequency| Dimension| Unit Weight|
Power| Plug
---|---|---|---|---|---
__
177GLXYGW
| __
120V 60HZ 1/3 HP
| __
8″W x 12″D x 18″H
| 23lbs .
(26 lbs . shipping)
| __
1/3 HP
| __
NEMA 5-15
Troubleshooting
Problem: The glass washer does not work after being switched on.
- Make sure the glass washer is plugged in correctly.
- Be sure it is switched on.
- Check with the service center.
Problem: There is a very loud noise when the glass washer is in use.
- Do not attempt to dismantle the glass washer.
- Contact your service agent right away to examine the motor and inside gears.
Problem: The brush spin cycle is slow and the glasses are not cleaned properly.
- Check to see if something is jammed inside the brushes.
Part List
NO PART NAME SPEC.
1| POWER CORD| 5-15 SJOW
16AWG
2| POWER SWITCH| 125V 15A
3| CAPACITOR MOTOR| 120V 240W
4| CONNECTION POLE| Aluminum
5| EXTERIOR TUBE| Stainless Steel
6| SUPPORTING BOARD| Stainless Steel
7| DRIVING WHEEL| Plastic
8| GEAR| Plastic
9| GEAR HUB| Copper
10| BASE BOARD| Stainless Steel
11| FOOT| Rubber
12| SEPTA PILLAR| Stainless Steel
13| LOWERING BEARING SHAFT| __
Rubber
14| BASE COVER| Silicone
15| BIG BRUSH| Plastic
16| SMALL BRUSH| Plastic
17| UPPER BEARING SHAFT| Rubber
18| DRIVING SHAFT| Stainless Steel
Equipment Limited Warranty
Noble Products warrants its equipment to be free from defects in material and workmanship for a period of 6 months. This is the sole and exclusive warranty made by Noble Products covering your Noble Products brand equipment. A claim under this warranty must be made within 6 months from the date of purchase of the equipment. Only the equipment’s original purchaser may make a claim under this warranty. Noble Products reserves the right to approve or deny the repair or replacement of any part or repair request. The warranty is not transferable. Noble Products Equipment installed in/on a food truck or trailer will be limited to a period of 30 days from the original date of purchase. To Make a Warranty Claim: For Warranty, Inquiries contact the location where you purchased the product:
- WebstaurantStore.com: Contact help@webstaurantstore.com. Please have your order number ready.
- The Restaurant Store: If you purchased this unit from your local store, please contact your store directly.
- TheRestaurantStore.com: For online purchases, call 717-392-7261. Please have your order number ready.
Failure to contact the designated location prior to obtaining equipment
service may void your warranty. Noble Products makes no other warranties,
express or implied, statutory or otherwise, and HEREBY DISCLAIMS ALL IMPLIED
WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS
FOR A PARTICULAR PURPOSE.
This Limited Warranty does not cover:
- Equipment sold or used outside the Continental United States
- Use of unfiltered water (if applicable)
- Noble Products has the sole discretion on wearable parts not covered under the warranty
- Equipment not purchased directly from an authorized dealer
- Equipment used for residential or other non-commercial purposes
- Equipment that has been altered, modified, or repaired by anyone other than an authorized service agency
- Equipment where the serial number plate has been removed or altered.
- Damage or failure due to improper installation, improper utility connection or supply, and issues resulting from improper ventilation or airflow.
- Defects and damage due to improper maintenance, wear, and tear, misuse, abuse, vandalism, or Act of God.
Any action for breach of this warranty must be commenced within 6 months of the date on which the breach occurred. No modification of this warranty, or waiver of its terms, shall be effective unless approved in a writing and signed by the parties. The laws of the Commonwealth of Pennsylvania shall govern this warranty and the parties’ rights and duties under it. Noble Products shall not under any circumstances be liable for incidental or consequential damages of any kind, including but not limited to loss of profits.
References
- The Restaurant Store: Restaurant Equipment & Supplies
- WebstaurantStore: Restaurant Supplies & Foodservice Equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>