SIRHC LABS Transbrake Bump Driver Instruction Manual

June 3, 2024
SIRHC LABS

Table of Contents

[

SIrchLabs](https://manuals.plus/wp- content/uploads/2022/12/SIrchLabs.png)

SIRHC LABS Transbrake Bump Driver

SIRHC-LABS-Transbrake-Bump-Driver

INSTALLATION INSTRUCTIONS

The Transbrake Bump Driver is required to utilize the Cortex EBC’s transbrake bump control functionality. These drivers can be used with any one-wire or twowire transbrake solenoid that draws 20 Amps or less. The Transbrake Bump Driver is specifically designed for transbrake bump control, and should not be used to provide PWM control for high-speed solenoids.

INCLUDED COMPONENTS

  • Transbrake Bump Driver
  • 12 V Diffused Indication LED (Red, Green Blue)

CONTROL DEVICE COMPATIBILITY
Cortex EBC

ACTIVATION METHOD
The Transbrake Bump Driver is activated by pulling the control input (purple wire) to ground.

CONTROL INPUT PULL-UP RESISTANCE
500 Ω pull-up to supply voltage

MAXIMUM CURRENT
20 Amps

MAXIMUM PWM FREQUENCY
N/A

SIZE
66.5 mm x 50 mm x 20 mm (2.62 in x 1.97 in x 0.79 in)

ONE-WIRE SOLENOID WIRING DIAGRAM[

SIRHC-LABS-Transbrake-Bump-
Driver-1](https://manuals.plus/wp-content/uploads/2022/12 /SIRHC-LABS-Transbrake-Bump-Driver-1.png)

TWO-WIRE SOLENOID WIRING DIAGRAM[

SIRHC-LABS-Transbrake-Bump-
Driver-2](https://manuals.plus/wp-content/uploads/2022/12 /SIRHC-LABS-Transbrake-Bump-Driver-2.png)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals