SIRHC LABS 1999-2004 Mustang GT 4.6L Cortex EBC Instructions
- June 3, 2024
- SIRHC LABS
Table of Contents
CORTEX EBC
1999-2004 Mustang GT 4.6L Specific Instructions
Rev 3.0.0
1999-2004 Mustang GT 4.6L Cortex EBC
WIRING
The 1999-2004 Mustang PCM is inside the vehicle behind the kick panel in the
passenger side foot well near the door. The PCM has a single 104-pin
connector. Power, ground, RPM, vehicle speed, and throttle position signals
can be accessed at the PCM connector.
The Cortex EBC wiring harness can be connected to the 104-pin PCM connector as outlined in the following table. RPM and vehicle speed signals are required for boost by gear applications.
CORTEX EBC TO PCM CONNECTIONS
CORTEX SIGNAL| CORTEX WIRE COLOR| PCM SIGNAL| PCM PIN|
PCM WIRE COLOR
---|---|---|---|---
+12V Power| Red| Switched PCM Power| 71| Red
Ground| Black (x2)| Connect to Chassis Near EBC| N/A| N/A
Engine Speed| Pink| Camshaft Position Sensor| 85| Dark Blue / Orange
Vehicle Speed| Green| Vehicle Speed Output| 68| White / Orange
General-Purpose| Orange| Throttle Position| 89| Gray / White
VEHICLE CONFIGURATION SETTINGS
RPM DETECTION:
- Mode: RPM
- Pulses Per Cycle: 1
- Rotations Per Cycle: 2
GEAR DETECTION
• Follow the steps in the Setup – Gear Detection section of the Help utility to determine the correct EVS ratio settings for gear detection.
SPEED DETECTION
- Follow the steps in the Setup – Vehicle Speed Detection section of the Help utility to determine the correct Pulses Per Mile setting.
- NOTE: Gear detection setup should be performed before calibrating the Pulses Per Mile setting.
THROTTLE POSITION DETECTION:
- Follow the steps in the Setup – Throttle Position Detection section of the Help utility to determine the correct Closed TPS Voltage and Open TPS Voltage settings.
SIRHC Labs 2022
Documents / Resources
|
SIRHC LABS 1999-2004 Mustang GT 4.6L Cortex
EBC
[pdf] Instructions
1999-2004 Mustang GT 4.6L Cortex EBC, 1999-2004, Mustang GT 4.6L Cortex EBC,
Cortex EBC, EBC
---|---