Eccel Actioncam User Interface RFID Unit User Manual
- June 5, 2024
- Eccel
Table of Contents
Eccel Action cam User Interface RFID Unit
Device overview
Picture 1.1 – Front View
- RFID antenna
- 7”LCD screen
Picture 1.2 – Angled Rear View
- RJ45 connector (LAN/PoE)
- GPIO header
Electrical/Power
The device shall be powered by using the RJ45 Ethernet connector using a supply meeting the PoE standard. Maximum power consumption is 5W.
PoE/LAN Connection
The device is powered by the PoE connector. Network configuration should be
provided by the DHCP server. If the device does not get an IP address assigned
from the local network, then a message is displayed on the screen alerting the
user that there is no connection to the server.
This is the only working mode of the unit.
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC 15.105(b) – Information to the user/installer
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15.21 – Information to the user/installer
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>