MY PROJECT 383712 LED Inspection Lamp Instruction Manual

June 3, 2024
my PROJECT

MY PROJECT logo 383712 LED Inspection Lamp
Instruction ManualMY PROJECT 383712 LED Inspection
Lamp

383712 LED Inspection Lamp

MY PROJECT 383712 LED Inspection Lamp - Figure 1

Introduction

Congratulations!
With your purchase you have chosen a high-quality product.
The operating instructions are an integral part of this product. They contain important information for safety, use and disposal. Familiarise yourself with all of the operating  and safety information before using the product. Use the product only as described and for the specific areas of application. Keep the instructions for future reference.  Provide all of the documentation when passing the product on to third parties.
Hereinafter, the LED Inspection Lamp will be referred to as the product.

Explanation of symbols
The following symbols and signal words are used in these operating instructions, on the product or on the packaging.

WARNING!
This signal symbol/word indicates a hazard with a high level of risk which, if not avoided, may result in death or serious injury.
CAUTION!
This signal symbol/word indicates a hazard with a low level of risk which, if not avoided, may result in minor or moderate injury.
NOTE!
This signal word warns of possible property damage or provides you with useful additional information regarding the use.

| This symbol indicates interior use only.
---|---
| This symbol indicates usage.
| This symbol indicates the cable length.
| This symbol indicates the ON/OFF switch.
| This symbol indicates alternating current.
| This symbol indicates the electrical power: watts.
| This symbol provides information regarding the maximum illuminance.
| This symbol indicates Pro-tection Class IP20. (No protection against water, but against solid  objects of more than 12.5 mm diameter. The product may only be used in a dry environment.)
| This symbol indicates protection class II.
| These symbols inform you about the disposal of the packaging and the product.
| Certified safety: Products marked with this symbol comply with the requirements of the German Product Safety Act (ProdSG).
| Conformity declaration (see chapter „8. Conformity declaration”):
Products that are marked with this symbol fulfil all applicable Community regulations of the  European Economic Area.

Safety Intended use

WARNING!
Risk of injury!
The product may not be used near liquids or in damp spaces.
There is a risk of injury from electric shock!
The product is not intended for commercial use. Different use or a modification to the product are not deemed as intended use and may lead to risks, such as injuries and damage. The distributor assumes no liability for damage that results from improper use.
The product is exclusively suitable for interior use.
The product is not suitable for household room lighting.
The product is intended as a mobile tubular light for normal operation.

Scope of delivery (Fig. A)

1x LED Inspection Lamp 1
1x Operating instructions (not shown)

Technical specifications

Type: LED Inspection Lamp
IAN: 383712 – 2110
Tradix Item No.: 354241-21-A
Light bulb: max. 5 W COB LED
Total output: 4.8 W
Luminous flux: 400 lm
Protection class: II
Protection type: IP20
Input voltage: 230 V / 50 Hz
Power supply cable: 5 m
Production date: 04/2022
Warranty: 3 years

Safety information

WARNING!
Risk of strangulation and suffocation!
If children play with the product or the packaging, they could become caught in it and suffocate!

  • Do not let children play with the product or the packaging.
  • Supervise children who are close to the product.
  • Keep the product and the packaging out of the reach of children.

WARNING! Risk of injury! 8 Not suitable for children under the age of 8! There is a risk of injury!

  • Children from the age of 8, as well as people with impaired physical, sensory or mental capabilities or with a lack of experience and knowledge, must be supervised when using the product and/or be instructed regarding the safe use of the product and understand the resulting dangers.
  • Children are not allowed to play with the product.
  • Maintenance and/or cleaning of the product is not allowed to be performed by children. Observe national regulations!
  • Observe the applicable national requirements and regulations for the use and disposal of the product.

WARNING!
Risk of injury!
Do not use in an explosive environment!
There is a risk of injury!

  • The product is not allowed to be used in an explosive (Ex) environment. The product is not  approved for an environment, in which flammable liquids, gases or dust are  present.

WARNING!
Risk of injury!
A defective product is not allowed to be used! There is a risk of injury!

  • Do not use the product in the case of malfunctions, damage or defects.
  • Significant danger can occur for the user in the case of improper repairs.
  • If you find a defect in the product, have the product checked and repaired if necessary before putting it back into operation.
  • The LEDs are not replaceable. If the LEDs are defective, the product must be disposed of.
  • The cable is not interchangeable. If the cable is defective, the product must be disposed of.

WARNING!
Risk of injury!
The product is not allowed to be
manipulated! There is a risk of injury from electric shock!

  • The casing must not be opened and the product must not be manipulated/modified under any circumstances. Manipulations/modifications can cause danger to life from  electric shock. Manipulations/modifications are prohibited for approval reasons (CE).
  • Check voltages! Make sure that the existing mains voltage corresponds to the specification on the rating place. Failure to comply can lead to excessive heat development.
  • Never touch the power plug with wet hands, if it is in operation.
  • The product must not be covered up during use.

CAUTION!
Danger of overheating!
Remove packaging prior to use.

Start-up

  1. Remove all packaging materials.
  2. Check whether all parts are available and undamaged.

If this is not the case, notify the specified service address.
Hanging up the lamp The suspension hook 3 is freely rotatable.

  • Hang up the lamp 1 on an existing hook or on a string.

NOTE!

  • Make sure that the hook or the string can bear the weight of the lamp 1 .
  • Do not attach the lamp 1 to hot items. The suspension hook 3 could become deformed.
    Laying the lamp down
    Lay the lamp 1 in a suitable place and direct the light beam to the desired area.

NOTE!

  • Place a base underneath the product. Sensitive surfaces could become scratched by the product.

WARNING!
Risk of injury!
The product may not be placed on damp or wet surfaces or in water.
There is a risk of electric shock!

  • Only place the product on dry surfaces.
  • Make sure that the power cable cannot be damaged by sharp edges or hot objects.
  • Do not place the product on hot surfaces.
  • Unplug the power plug from the wall outlet when the product is not in use.

Use

  1. Insert the power plug 2 into a properly installed wall outlet, see Fig. B.
  2. Switching the product on/off:
    – Press the ON/OFF switch 4 , see Fig. C.

NOTE!
The wall outlet should be easily accessible so that the power plug can be pulled out quickly if necessary.

Cleaning and care instructions

WARNING!
Risk of injury!
The power plug must be disconnected before cleaning.
There is a risk of electric shock!

  • only clean with a dry cloth
  • do not use any strong detergents and/or chemicals
  • do not immerse in water
  • store in a cool, dry place and protected from UV light

Conformity declaration

This device complies with the fundamental requirements and other relevant regulations of the European Electromagnetic Compatibility Directive 2014/30/EU and the  RoHS Directive 2011/65/EU. The complete original conformity declaration is available from the importer.

Disposal

Disposal of the packaging The packaging and operating instructions are made of 100 % environmentally friendly materials, which you may dispose of at local recycling  centres.

Disposal of the product
The product may not be disposed of with normal household waste. For information on disposal options for the product, please contact your local council/ municipality or your Kaufland shop.

Warranty

Dear customer, the warranty on this product is 3 years from the purchase date. In the event of defects in this product, you are entitled to exercise your statutory rights against the seller of the product. These statutory rights are not limited by our warranty described in the following.
Warranty conditions
The warranty begins on the date of purchase. Please keep the original receipt. This document is required as verification of the purchase. If a material or manufacturing defect arises within three years from the purchase date of this product, the product will be repaired or replaced, as per our choice, at no charge to you. This warranty service requires the submission of the purchase receipt and the defective product within the threeyear period and a short written description of the defect and when it arose. If the defect is covered by our warranty, the repaired or a new product will be returned to you. The warranty period does not restart with the repair or replacement of the product.
Guarantee period and statutory claims for defects
The guarantee period will not be extended by the warranty.
This also applies to replaced and repaired parts. Damage and defects which may possibly already exist upon purchase must be reported immediately after unpacking. After the guarantee period has expired, required repairs shall be subject to a charge.
Scope of guarantee
The device has been carefully produced under strict quality guidelines and conscientiously inspected prior to delivery. The guarantee service applies to material or manufacturing faults. This guarantee does not extend to product parts, which are exposed to normal wear and tear and can therefore be regarded as wearing parts or to damage to fragile parts, e.g. switches, battery packs or which are made of glass. This guarantee shall lapse, if the product is damages, not used properly or maintained properly. For proper use of the product, all of the instructions in the operating instructions must be precisely complied with. Purposes and actio

MY PROJECT 383712 LED Inspection Lamp - qr 2http://www.kaufland.com/manual

On www.kaufland.com, you can download these and many other manuals, product videos and installation software.
With this QR code, you can directly reach the Kaufland Service website (www.kaufland.com) and can open your operating instructions by entering the article number (IAN 383712-2110).

Distributor
TRADIX GmbH & Co. KG Schwanheimer Str. 132
Country of origin: China
Service address
Hotline: 00800 30012001
(kostenfrei, Mobilfunk abweichend
E-Mail: [email protected] 
04/2022
Tradix Art.-Nr.: 354241-21-A
IAN 383712 – 2110

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

my PROJECT User Manuals

Related Manuals