VISUAL COMFORT KW 4033 Utopia Large Flush Mount Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
COMFORT KW 4033 Utopia Large Flush Mount
**Instruction Manual
**
ASSEMBLY INSTRUCTIONS
KW 4033 Utopia Large Flush Mount
Utopia Large Flush Mount
Item # KW 4033
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver……………
Slotted Screwdriver………………..
Drill……………..
Pencil………………
Hammer……………………
PERSONS REQUIRED: Two
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture (G) by removing screws (F).
-
Using mounting plate (B) as a guide, line up with the junction box and mark anchor positions.
-
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes using a hammer.
-
Install mounting plate (B) to the junction box and secure with mounting screws (D), then secure wood screws (C) to anchors (A).
NOTE: It is recommended to have a helper assist in supporting the fixture for steps 6-11. -
Run support cable through the hole on the back of the mounting plate (B). Loosen cable lock and install to end of support cable. Insert another end of the cable through the cable lock and tighten the ends with a screwdriver to secure. (see diagram 1)
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 2). Tighten.
-
Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (E).
NOTE: It is imperative that the fixture is grounded. 8. Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (E).
ASSEMBLY INSTRUCTIONS
Utopia Large Flush Mount Item # KW 4033
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. -
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (E). CAUTION: Do not reverse the hot and neutral connections.
-
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install fixture (G) to mounting plate (B) and secure with screws (F).
Care Instructions:
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>