SECURITY BRANDS 25-S1 Ascent Switch Installation Guide
- June 4, 2024
- SECURITY BRANDS
Table of Contents
SECURITY BRANDS 25-S1 Ascent Switch
- Unpack the box and make sure you have all the items shown here.
- Remove screws and open unit cover for wiring and setup.
IMPORTANT
This Ascent unit WILL NOT WORK until the activation process is COMPLETE! See
the included Activation Guide to get this unit activated. If you need help or
have any questions, please contact Summit Control at
972-474-6422.
WARNING
AUTOMATIC GATES CAN CAUSE SERIOUS INJURY OR DEATH! ALWAYS CHECK THAT THE GATE
PATH IS CLEAR BEFORE OPERATING! REVERSING OR OTHER SAFETY DEVICES SHOULD
ALWAYS BE USED!
STOP
This is a cellular accessory for a gate or door. An uninterrupted cellular connection CANNOT BE GUARANTEED! An emergency egress or primary entry mechanism SHOULD ALWAYS BE USED! (transmitter, firebox, mechanical release) Consult with your dealer, distributor, and/or system designer for more information.
IMPORTANT
If mounting in a location that will shield the puck antenna, the 4G LTE
Antenna Extension Kit (Model 16-ANTX-1) should be purchased and installed.
Failure to do so may result in NO SIGNAL!
CAUTION
Leave the “hockey puck” antenna in place even if using an antenna extension.
Seal all openings created in the enclosure. Failure to follow these
instructions can damage the unit!
What’s what?
All important components labelled
- Unit shown with cover removed.
- Internal wiring is not shown for clarity.
Connect wires
Feed wires through one or both cable glands, and connect as shown using the included screwdriver.
- Consult gate/door opener manual for exact connections.
- Terminals vary widely across manufacturers and models.
- Additional wiring diagrams can be found online.
- We recommend using 18-gauge stranded wire for all connections.
CAUTION
When connecting the power supply, remember to connect positive to positive and
negative to negative to avoid damage. Reversing polarity can damage the unit
and void the warranty! Some power terminals may be different from that shown
and may be pluggable style.
STOP
Before going forward, double-check all wiring and make sure the unit has
power! A wiring diagram for connecting to Wiegand devices can be found below.
For connecting accessories not mentioned, please scan the QR code on this
page. Tighten cable gland locknuts, replace unit cover, and fasten screws.
INSTALLATION COMPLETE
Now follow the Activation Guide to create an account and begin using Ascent.
Need More?
Use the QR code below to get access to more resources, including how-to videos
and additional wiring diagrams for connecting accessory devices.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>