mars GNB LAB Alle Lux 5 Lamp Instruction Manual
- June 3, 2024
- MARS
Table of Contents
GNB LAB Alle Lux 5 Lamp
Instruction Manual
GNB LAB Alle Lux 5 Lamp
LAMP ALLE LUX 5
Technical specifications:
Number of UV LEDs: 24 Max
Power: 48W
Wave lenght UV: 365+405nm
Power: Rated input: 100/240V 50/60Hz 1A
Size: 220 x 195 x 105mm
lamp model : SUN 5
No. Certificate: MOSTCN19081612 MOSTCN19081613
Cures UV/Builder/LED gels.
Instructions:
- Infrared motion sensor.
- Power indicator
- Time switch button 10s
- Time switch button 30s
- Time switch button 60s
- Reduced heat mode (99s) / ON/OFF button
- Power supply
Operating instructions:
- Connect the device to the power supply.
- To turn on the lamp, hold the ON/OFF button for 1-2s. If the display the countdown starts, press the button again to enter the standby mode.
- You can select one of the available timer options 10s/30s/60s/99sec In 99s mode, the heating power is gradually increased so that you can reduce the effect of nail plate burning caused by gel curing.
- You can also start without choosing the time. To do this, put your hand in the device, and the heating will start automatically when the sensor detects movement. The maximum operating time is 120 s.
Warning: Use the correct voltage for the lamp. Protect the device from
contact with water and others fluids.
Do not use the lamp
– In damp rooms – If the power supply is damaged
– If the device or connection cable is damaged
– If the timer buttons are not working
The device should not be left in operation for more than 60 minutes, as this
may reduce its lifetime. When the device temperature is too high, the status
,,07p” will appear on the display. To resume operation, wait until the message
disappears.
If you notice sudden changes on your skin, consult a doctor immediately. The
device is designed for indoor use.
KEEP OUT OF THE REACH OF CHILDREN.
Documents / Resources
| mars
GNB LAB Alle Lux 5
Lamp
[pdf] Instruction Manual
GNB LAB Alle Lux 5 Lamp, LAB Alle Lux 5 Lamp, Lux 5 Lamp, 5 Lamp
---|---