e-peas AEM00330 Battery Charger User Guide
- June 3, 2024
- e-peas
Table of Contents
e-peas AEM00330 Battery Charger
FEATURES
Connectors
- 1 screw connector for the source 2 screw connector for AC input signal
- 1 screw connector 1 JST connector for the Storage Element
- 1 screw connector for the application supply
Configuration
- 6 jumpers SRC_LVL_CFG[x] to define the source voltage regulation
- 4 jumpers STO_CFG[x] to define the storage element protection levels
- 4 resistors footprint related to the custom mode (STO_CFG[3:0]=LHHH)
- 3 jumpers LOAD_CFG[x] to define the LOAD voltage
- 1 jumper to set the dual-cell supercapacitor BAL feature
- 4 jumpers to enable the different modes
- 1 jumper to select the rectifier
Size
- 79mm x 49mm
- 4 x M2.5 Mounting holes
SUPPORT PCB
BOM around the AEM00330
Footprint & Symbol: Information available in the datasheet
Configuration
STEP 1: AEM00330 Configuration
- STEP 2: Connect the storage element
- STEP 3: Connect the load to LOAD
- STEP 4: Connect the harvester
Internal Boost efficiency Vs. input voltage in Low Power mode:
STEP 5: Check the status
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>