e-peas AEM00940 Pulsed Ambient Energy Manager Board User Guide
- June 11, 2024
- e-peas
Table of Contents
- e-peas AEM00940 Pulsed Ambient Energy Manager Board
- Product Information
- Product Usage Instructions
- FAQ
- Overview
- FEATURES
- SUPPORT PCB
- Configuration
- Connection And Information
- Internal Boost efficiency Vs. input voltage 22μH LBOOST ****
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
e-peas AEM00940 Pulsed Ambient Energy Manager Board
Product Information
Specifications
- Model: AEM00940 Quick Start Guide EVK
- Support PCB
- BOM around the AEM00940
- Footprint & Symbol: Available in the datasheet
- Manufacturer Website: www.e-peas.com
Product Usage Instructions
Step 1: AEM00940 Configuration
Visit the manufacturer’s website and follow the instructions provided for configuring the AEM00940.
Step 2: Connect the Storage Element and Primary Battery
Connect the storage element and primary battery as per the guidelines provided in the user manual. Ensure proper connections are made.
Step 3: Connect the Load(s) to HVOUT / LVOUT
Connect the load(s) to HVOUT / LVOUT following the specified connections outlined in the user manual to power your devices.
Step 4: Connect the Harvester
Connect the harvester according to the instructions provided. Make sure to establish secure connections for efficient energy harvesting.
Step 5: Check the Status
After completing all connections, check the status of the AEM00940 to ensure everything is properly set up and functioning as expected.
FAQ
Q: Where can I find the datasheet for AEM00940?
A: The datasheet for AEM00940 is available on the manufacturer’s website at www.e-peas.com.
Overview
Quick Start Guide EVK
FEATURES
Pads
- 1 pad for the DC source
- 1 pad for the storage element
- 1 pad for primary battery
- 1 pad for HVOUT LDO output (80mA@ 1.8 – 4.1 V)
- 1 pad for LVOUT LDO output (20mA@ 1.2 or 1.8 V)
Configuration
- 2 solder pads SRC_LVL_RANGE[1:0] to define the input voltage regulation of the AEM
- 2 resistors to set the source voltage regulation
- 3 solder pads CFG[2:0] to define the storage element protection levels
- 6 resistors footprint related to the custommode (CFG[000])
- 2 solder pads to enable/disable the internal LDOs
- 2 solder pads to disable the primary battery feature
- 1 solder pad to set the dual cell supercapacitor BAL feature
Size
- 28mmx 28mm
SUPPORT PCB
BOM around the AEM00940
Footprint & Symbol: Available in the datasheet
Configuration
STEP 1: AEM00940 configuration
- Source level: Use the resistors R9 and R10 in combination of the source range functionality to define the harvesting voltage.
- RS = R9 + R10
- 100 kΩ ≤ RS ≤ 500 kΩ
- R10 = RS – R9
Connection And Information
- STEP 2: Connect the storage element (and the primary battery)
- STEP 3: Connect the Load(s) to HVOUT / LVOUT
- STEP 4: Connect the Harvester
Internal Boost efficiency Vs. input voltage 22μH LBOOST ****
STEP 5: Check the Status
QR Code
- www.e-peas.com
- © 2023 e-peas S.A.
- QSG-AEM00940_QFN28_miniEVK1.2-v1.0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>