SHARPER IMAGE 207825 Auto Vacuum Food Saver User Guide
- June 4, 2024
- Sharper Image
Table of Contents
SHARPER IMAGE 207825 Auto Vacuum Food Saver
Thank you for purchasing the Auto Vacuum Food Saver. Please take a moment to read this guide and store it for future reference.
INTRODUCTION
The Auto Vacuum Food Saver removes air to preserve your perishable foods. Just press a button to form an airtight seal around the included tray.
PRODUCT FEATURES
- Easy, one-button operation
- Ideal for bread, cookies and other dry foods
- Automatic sensor detects changes in pressure and re-starts the vacuuming process to restore an airtight vacuum seal
- 10-liter capacity (dome measures approximately 15.6″ L x 15.6″ W x 9.8″ H)
- Can also be used to marinate foods
- Cordless and battery-operated
- BPA free
SUGGESTED USES
Dry foods Bread, biscuits, cereals, cookies, cupcakes, etc.
Fruits and vegetables — This device can help extend the life of fruits,
vegetables and other produce. NOTE: be sure to open the dome for 10
minutes a day to release any extra moisture that is emitted from the food.
Marinating foods — The vacuum process helps your favorite marinade penetrate deep into meats, poultry and other foods for grilling, roasting and baking. Use it just 30 minutes for a rapid flavor infusion.
IDENTIFICATION OF PARTS
A. Auto-Vacuum Machine
B. Battery Cover
C. Vent Cap
D. Dome
E. Sealer
F. Two-Sided Tray
G. ON Button (Start Vacuum)
H. OFF Button (Air Release)
I. Battery Compartment
BATTERY INSTALLATION
This device operates on 2 disposable batteries (either C or AA). NOTE: Batteries are not included.
- Remove the Auto-Vacuum Machine.
- Unscrew the Vent Cap.
- Insert batteries in the direction shown inside. You may use either C cell batteries or AA batteries with the included adapters.
- Reverse the above stages and replace the Auto-Vacuum Machine.
OPERATION
- Place food onto the tray. NOTE: The tray is double-sided: one side is a flat tray, the other side is a deep tray.
- Screw the Auto-Vacuum Machine on top of the dome, securing it with the Vent Cap.
- Cover the tray with the dome, ensuring that the rim is clean and free of any debris that may hinder the suction process.
- COMLETELY PRESS downward on the ON button. The suction process with begin and continue until optimum pressure is achieved (approximately 3 to 6 minutes).
- Press down on the dome for at least 10 seconds during vacuuming to ensure secure contact with the tray. When optimum pressure is achieved, the vacuum will automatically stop.
- To open, COMPLETELY PRESS the OFF button to release the vacuum. This may take up to 10 seconds.
NOTE: The Auto-Vacuum Machine has a built-in sensor to monitor the level of vacuum pressure. If the vacuum level drops, the suction process will begin again to restore the optimum vacuum level.
PRO TIP: This device can be also used without the tray, i.e., on a table or countertop with a flat, smooth surface
CAUTION
- This device is not a substitute for refrigeration, canning or freezing.
- This device cannot reverse the deterioration of food. It can only slow down the process by maintaining food quality for longer time.
- For best results, avoid humidity and be sure there is no water or dampness inside the dome
CLEANING AND MAINTENANCE
- Wipe with a damp cloth and mild soapy solution if needed.
- Do not use abrasives or petroleum-based detergents.
- Do not immerse in water.
- Do not place Auto-Vacuum Machine in dishwasher (tray IS dishwasher safe).
- Keep away from open flames and extreme heat.
- Make sure vent is unblocked during use.
- Keep out of reach of children at all times.
- Do not attempt to disassemble or repair this device. There are no userserviceable parts.
- Please check and clean the air filter when you replace the batteries (see illustration).
- Do not use the handle to swing or shake the device.
- The weight of contents should not exceed 4.4 lbs. (2Kg).
TROUBLESHOOTING
If the device is not working, please check the following:
- Are the batteries fresh and inserted correctly?
- Is the table surface smooth?
- Is the dome surface clean and free of any debris that could hinder the suction process?
- Are you pressing the ON/OFF buttons completely?
IMPORTANT – FOR BEST RESULTS
- The Vent Cap must be securely fastened to the lid.
- Always keep the edges of the tray and the dome clean and free of any debris that could hinder the suction process.