Royal Mirrors LED Bathroom Mirror Instructions
- September 4, 2024
- Royal Mirrors
Table of Contents
LED Bathroom Mirror
“`html
Product Information
Specifications:
- Product: LED Bathroom Mirror
- Control: Sensor Touch
- Installation: Indoor solid wall
- Operating Hours: Mon-Fri 8am-5pm
- Helpline: 01452 317890
Product Usage Instructions:
Installation:
To ensure proper installation, follow these steps:
- Set out wires as per IEE regulations.
- Install on indoor solid wall only.
- Hire a professional electrician for installation to avoid
product damage and personal injury.
Cleaning and Maintenance:
-
Clean with a soft dry cloth only.
-
Avoid putting sharp materials against the mirror surface during
operation to prevent current leakage. -
Do not forcibly pull out the power lead during normal operation
to prevent damage to electric elements.
FAQ
Q: Can I install the LED bathroom mirror myself?
A: It is recommended to hire a professional electrician for
installation to prevent product damage and personal injury.
Q: What should I do in case of functional failure?
A: Do not disassemble or repair without authorization. Contact
the helpline for assistance.
“`
Instructions for LED bathroom mirror
(Applicable to sensor touch control)
Notes: to ensure the normal use of products, it is required set out wires as
per the regulations of IEE at the installation places. The products are only
applicable to being installed on the indoor solid wall, etc. The installation
must be executed by a professional electrician, and wrong installation may
lead to product damage and personal injury.
Please ensure products in installed by a qualified fitter in accordance with
current regulations. In case of functional failure of the product, users are
not allowed to disassemble and repair without authorization.otherwise, our
company will not be responsible for any safety accidents
Installation tools (as shown below)
a , ,…….’—–
Flexible rule
Leveling instrument
Churn drill
Screwdriver
Hammer
Installation instruction:
1, Make certain the wall is solid, and use the exible rule to measure the
centre distance between two hardy holes on the mirror frame (“a” in Fig. 2).
2, Use the exible rule to measure the centre distance between two hardy holes
on the wall (“a” in Fig. 2), and mark them out with a pencil. 3, Choose the
churn drill with an appropriate drill bit to make two holes at the marked
places, and use a special ceramic drill if the wall surface is made of ceramic
tiles. 4, Use the hammer to strike the expansion rubber plug in accessory bag
into the holes on the wall, and then use the screwdriver to tighten the screws
into the holes (exposure for 8 12mm). 5, Switch off the power, and then use a
terminal block to connect the three-core exposed wires with those reserved on
the wall (see details in Fig. 3) 6, Hang the product on the screw crossing two
hardy holes to fix it. 7, Finally, switch on the power, and then touch the
“Switch” sign (Fig.1) with a finger on the lens to test the products.
(a)
Cleaning and maintainence
@, Clean only with a soft dry cloth
@, During operation never put sharp materials directly against the mirror
surface as this may result in current leakage and even pesonal injury
@, During normal operation never forcibly pull out the power lead to stop the
product or the electric elements of the product may be damaged
©, Please switch off the power if the product is
not going to be used for a long time
Fig. 1
“Switch” sign
Fig. 2
Helpline: 01452 317890 Mon~Fri: 8am~5pm
D06
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>