kvm-tec KT-6031L USBflex Single DVI/USB CAT Extender Installation Guide

kvm-tec KT-6031L USBflex Single DVI/USB CAT Extender Installation Guide

Update with USB-Stick

1. Plug the USB stick with update file into USB Flex.
2. press the button on the back left (if PtP, the USB channel will be disconnected) ~ 4 sec
3.  wait until LED flashes orange (USB stick is scanned for updates) ~ 10-20 sec
4. LED lights up specifically for 3 seconds LED red -> no update on stick found (remove stick and start at step 1) LED green -> Update found, ready to start
5. press button again
6. wait until the update is completed or an error occurs (for PtP local is updated first) ~ 2-3 min (PtP ~ 5-6 min) While update is running, LED flashes green, if data is transferred or copied, LED flashes very fast.
   At the end of the update, the LED flashes orange 4 more times and then starts the reboot process (the Extender must not be disconnected from the power supply during this process!)

Quick Installation USBflex

local / CPU – remote/ CON

Misprints, errors and technical changes reserved

http://www.kvm-tec.com/

References

• Kvm-tec.com: KVM Extender over IP - Matrix Switching Systeme

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>