kvm-tec KT-6032L USBflex fiber Extender IP Instruction Manual
- June 3, 2024
- kvm-tec
Table of Contents
USB Fles
kvm-tec
Quick
Installation
KT-6032L CPU/LOCAL
KT-6032R CON/REMOTE
KT-6032L FLEXline Full HD Extender over IP
Quick Installation USBflex Fiber local / CPU – remote/ CON
- Connect the CON / Remote and the CPU / Local Unit to the included 12V 2A power supply.
- Now connect the USB cable to a USB port on your PC and connect the other end of the USB cable to the CPU / Local Unit. Connect some USB devices to the CON / Remote Unit.
- Connect the CPU / Local and the CON / Remote Unit with a network cable.
HAVE FUN – your kvm-tec Extender is now in use for many years ( MTBF approx 10 years)
First Aid
Your Extender….
Misprints, errors and technical changes
reserved
Update with USB-Stick
- Plug the USB stick with update file into USB Flex.
- press the button on the back left (if PtP, the USB channel will be disconnected) ~ 4 sec
- wait until LED flashes orange (USB stick is scanned for updates) ~ 10-20 sec
- LED lights up specifically for 3 seconds LED red -> no update on stick found (remove stick and start at step 1) LED green -> Update found, ready to start
- press button again
- wait until the update is completed or an error occurs (for PtP local is updated first) ~ 2-3 min (PtP ~ 5-6 min) While update is running, LED flashes green, if data is transferred or copied, LED flashes very fast. At the end of the update, the LED flashes orange 4 more times and then starts the reboot process (the Extender must not be disconnected from the power supply during this process!)
http://www.kvm-tec.com/videos/videos-
installation-channel
www.kvm-tec.com
kvm-tec Support
support@kvm-tec.com
Phone: +43 2253 81912 – 30
Documents / Resources
| kvm-
tec KT-6032L USBflex fiber Extender
IP
[pdf] Instruction Manual
KT-6032L USBflex fiber Extender IP, KT-6032L, USBflex fiber Extender IP, fiber
Extender IP, Extender IP
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>