COMFAST AX1808 Dual Band Wireless USB Adapter User Manual
- June 3, 2024
- COMFAST
Table of Contents
AX1808 Dual Band Wireless USB Adapter
User Manual
Introduction
Thank you for purchasing the wireless 802.11b/g/n/a/ac USB adapter!
This adapter is mini size design and you are able to plug it into the USB
port. Excepting common wireless standards 802.11b/g/n, this wireless adapter
is also 802.11ac compatible – data transfer rate is 150/433Mbps, and that’s
three times faster than 802.11g wireless network! 
System Support: Windows XP/Vista/Win7/8/10/Mac
Quick Installation Guide
-
Insert CD into your computer’s CD drive, double click “D” Drive OR you can open the “D” drive.
-
Select proper file for your system “Windows/Mac/Linux”
-
Select your system “Win/Mac/Linux”,follow the direction to finish the installation
-
2.Double left-click on the setup.exe file and follow the direction to finish the installation.
-
Once the installation is finished the computer will be asked to reboot. you can click ‘Finish’ and reboot the computer to finish the installation of driver files.
-
A new icon will appear near the clock of system tray: Connect to the Internet:
-
Wireless utility will appear. Click ‘Available Network’ menu to search for wireless access points nearby.
-
Choose your network and enter the password
-
Connection successful(if you entered the password,but network don’t work,pls try to return your Router)
AP mode for Win8.1/8/7/vista/xp/2000
Right-click Client configuration utility icon, and click Open Config Utility
Select Mode and then select Access Point.
It requires few seconds to switch to AP mode, please be patient
Client mode icon
AP mode icon
Configure SSID and Channel
Please note that Ad-Hoc mode is not available when network card is in AP
mode
Quick Installation Guide for MAC
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The frequency stability of all transmission frequencies of U-NII-1 and U-NII
-3 meets the 47 CFR FCC Part15.407(g) requirements, and the manufacturer
states that their transmissions remain within the U-NII-1 and U-NII -3 bands.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>