KNOP TR303410HF, TR303417HF Pressure Mat User Manual
- June 3, 2024
- KNOP
Table of Contents
TR303410HF, TR303417HF Pressure Mat
User Manual
Warnings and safety instructions
- The battery in this product must comply with the relevant IEC safety standards for batteries.
- Do not consume or eat the battery, risk of chemical burns.
- Keep new and used batteries away from children.
- If the battery compartment cannot be closed properly, discard the product, and keep it away from children.
- Read the intended use before use.
Intended use
TR30341XHF can be used in front of the bed or at the door.
If the transmitter is coded together with a KNOP 901 series receiver, the
patient’s name and apartment number can be displayed if this is coded.
Commissioning
The product is ready to use and only needs to be encoded in the desired receivers.
Check the coverage area
One person activates TR30341XHF (as described above) at short intervals, while
another person systematically walks around the area and marks on a sketch the
building and the area where there is coverage. The sketch is placed in the
office so that everyone who needs to use the system can see where there is
coverage.
Outside the coverage area, alarms cannot be received.
The coverage area can be extended by using a repeater system from Knop
Elektronik.
Contact your retailer for more information.
Changing the battery
TR30341XHF uses a CR2450 lithium battery.
Replace by removing the screws on the back Open the screws on the back of the
TR30341XHF and gently tighten the cover to replace the battery.
When an alarm is sent to an RX901A, B, or C, the display may show “Low
Battery” when the battery needs to be replaced.
Spare parts and accessories
Spare parts and accessories can be ordered from Knop Elektronik A/S at www.knop.dk.
Technical data
Order number:| TR303417HF, 70x40cm
TR303410HF, 110x70cm
---|---
Frequency HF:| 869.2125 MHz (FM)
Range:| Up to 500 m of an unobstructed view to an RX901B(¹)
Battery type:| 1 pc. 3V CR2450 type lithium
Operating time (expected)| 3 years with 5 transfers per day.
Up to 10 years, with one transfer per day.
Low battery alarm/indicator:| 1/3 remaining capacity.
Surrounding environment:| Indoor use. ≤ 90% non-condensing
Ambient temperature:| 0°C to +40°C
Colour of the cabinet:| Colour: Care yellow
Density:| IP54
Connections:| None
Weight:| 3,5kg/8,5kg
Accessories:| see knop.dk
The right to make changes is reserved.
All rights reserved.
© KNOP Elektronik A/S
(¹) Measured outdoors with an unobstructed view between transmitter and
receiver. In buildings, the range is reduced.
Explanation of symbols and approvals
| This product complies with:
Directive 2017/745/EU: MDR
Directive 1907/2006/EU: REACH
Directive 2011/65/EU: RoHS
ISO 14971:2019: Risk Management for Medical devices
EN 301 498-1 V2.2.3: Electro Magnetic Compatibility
EN 301 489-3 V3.1.1: Electro Magnetic Compatibility
EN 50130-4:2011 + 2014: Immunity alarm systems
EN 300 220-1 V3.1.1: Short Range Devices
EN 300 220-2 V3.1.1: Short Range Devices
EN 300 220-3 V2.1.1: Short Range Devices
EN 60601-1-2:2014 + 2015: Electromagnetic compatibility (Medical)
EN 62368-1:2020: Electrical safety
EN 50581:2012: Hazardous substances
---|---
| The product must not be used if the packaging is damaged.
| Medical Device
Klass 1
| Manufacturer
KNOP Elektronik A/S, Fabriksvej 20, DK-7600 Struer, Denmark
| Read the manual(s) before installation and commissioning.
| Interference may occur in an environment with equipment marked with this
symbol.
| Can be protected against liquids before installation.
| 0 °C to +40 °C, temperature limit for transport/storage and use.
| The product must not be disposed of with normal household waste.
| Single registration number
DK-MF-000025631
| Unique Device Identifier
05744002850441
05744002853442
05744002855446
| Product reference
POS901, Position Rod
POS901L, Position Loop
POS901S, Position Slave
| Serial number
Placed on the product
| Ingress Protection Code
IP20
© KNOP Elektronik A/S
Fabriksvej 20
DK-7600 Struer
knop@knop.dk
knop.dk
+45 97840444