beamZ StrobeMoon 2-in-1 Party Effect User Guide
- June 3, 2024
- beamZ
Table of Contents
BEAMZ
MADE EAZY 153.676 V1
STROBEMOON
QUICK START GUIDE
UNPACKING INSTRUCTION
CATUTION! Immediately upon receiving the product, carefully unpack the
carton, check the contents to ensure that all parts are present, and have been
received in good condition. Notify the shipper immediately and retain packing
material for inspection if any parts appear damage from shipping or the
package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it
is important that the product be returned in the original factory box and
packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached
room temperature.
POWERSUPPLY
WARNING! On the label on the backside of the unit is indicated on this
type of power supply must be connected. Check that the mains voltage
corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged.
The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply. Always connect the unit to a protected
circuit (circuit breaker or fuse). Make sure the unit has an appropriate
electrical ground to avoid the risk of electrocution or fire.
RIGGING
The unit may be set up on a stable and even surface. By means of the fixing
facilities of the baseplate, the unit can also be mounted upside down to a
truss, see below picture. For fixing, certified clamps with correct save
working load are required. The mounting place must be of sufficient stability
and be able to support a weight of 10 times of the unit’s weight. Secure the
unit with a safety cable so that it cannot fall down.
When carrying out any installation, always comply European and national
guidelines concerning rigging, truss and all other safety issues. Always let
the installation checked out by an authorized dealer !
REMOTE CONTROLLER
DMX MODE
No function
Press BLACK OUT off existing modes. Press BLACK OUT return the last
modes.
AUTO MODE
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press AUTO on the remote controller.
2. Press+ or -to choose between the different auto programs.
SOUND MODE
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
- Press SOUND on the remote controller.
- Press + or – to choose between the different sound programs.
To adjust the speed of the automatic program and the sound active program.
SPEED MODE
- PressSPEED on the remote controller.
- Press+ or- to either increase or decrease the speed of the program.
FLASH MODE
- PressFLASH on the IRC.
- Press+ or- to adjust the flash rate.
- Press FLASH again to turn off the flash.
CONTROL MENU
| MENU | DESCRIPTION |
|---|---|
| STAT | S01-20 |
| AUTO | Au1-4 |
| SOUN | Sol-4 |
| SPEE | SP1-9 |
| SENS | SE1-9 |
| DIMM | DI1-9 |
| STRO | on/oFF |
| SILE | on/oFF |
| INFR | on/oFF |
YOUR FUTURE
YOUR SKILLS
YOUR PLATFORM
YOUR PARTY
is a leading developer of lighting products. including intelligent DMX moving
heads. wireless battery operated DMX effects, static washes, sound-activated
club effects, strobes & blacklights. LED lighting. fog and special effects
machines. lasers and indoor and outdoor architectural lighting, as well as
lighting controllers and protective bags.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>