PULSAR GiGi H2O Best Vape Pen for Prefilled Cartridges User Manual
- June 3, 2024
- Pulsar
Table of Contents
PULSAR GiGi H2O Best Vape Pen for Prefilled Cartridges
Not intended for tobacco or illegal substances.
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov.
KIT INCLUDES
- Variable Voltage 500MaH Battery
- USB-G Charger
- 14/19mm Male Waterpipe Adapter
QUICK START
Power On/Off – 5 Clicks
- Variable Voltage Adjust
- 3 Clicks to Cycle Through
- 2. 6V 3.4V 4.0V
Preheat Function
- 2 Clicks to Activate
- 5 Minute Auto Shut Off
ATTENTION
- Only use a wall charger no larger than 5V 1A output.
- Atomizer Applicable řesistance:1.0 -3.0 .
CHARGING
- Power off unit prior to charging.
- Remove cartridge (not included) prior to charging.
- For the best charging experience, use wall charger to charge device. Never use a car adapter. Do not charge longer than 2 hours.
ADAPTER USE ON WATERPIPE
- Pull open silicone plug on the bottom of unit.
- Screw on waterpipe adapter to a snug fit [do not overtighten).
- Place unit onto waterpipe [fits 14mm & 19mm female fittings].
- Allow one preheat cycle to prime the cartridge.
- Select your preferred heating mode.
- Start your vaping session by pressing the power button and holding or just pull to activate via autodraw. Auto draw will activate automatically.
CLEANING
- Open bottom silicone plug.
- Wipe clean with 91% isopropyl alcohol using a dampened cotton-tipped swab.
- Wipe and twist until cotton-tipped swab is clean.
- Poke through the connector hole inside of the unit with a small pin, needle or toothpick to clear the airpath way. Oil will collect naturally in this area. Repeat this step with the adapter as well to keep airflow pathways open.
Manufactured by Pulsar
- Asheville, NC 28806 Designed in USA Made in China
Fits most 510 threaded cartridges
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>