Bemko V7-2 Current Circuit Breaker Instruction Manual
- September 29, 2024
- BEMKO
Table of Contents
Bemko V7-2 Current Circuit Breaker
Specifications:
- V7-2: 240V~ 50/60Hz
- V7-4: 415V~ 50/60Hz
- In: 25A/40A/63A
- In: 30mA/100mA/300mA
- Inc=Ic: 10kA
- Ui: 500V 6000x
- Im=Im: AC 25A/40A: 500A, 63A: 630A
- 25mm2
- Uimp: 4kV
- IP20
Product Usage Instructions
Installation:
- Refer to the provided installation guide for specific wiring instructions.
- Ensure the power source is switched off before beginning the installation process.
- Connect the appropriate wires as per the labeled terminals on the product.
- Secure all connections properly to avoid any loose wiring.
- After installation, double-check all connections before turning on the power.
Safety Guidelines:
- Do not attempt to install the product if you are not familiar with electrical systems.
- Avoid installation in wet or damp environments to prevent electrical hazards.
- If in doubt, consult a professional electrician for installation assistance.
FAQ:
-
Q: Can this product be used outdoors?
A: No, this product is recommended for indoor use only due to safety reasons and environmental factors. -
Q: What should I do with old electrical products?
A: Waste electrical products should not be disposed of with household waste. Please recycle them where facilities exist. Check with your local authority or retailer for recycling advice.
RESIDUAL CURRENT CIRCUIT BREAKER
Installation instructions
Waste electrical products should not be disposed with household waste. Please
recycle where facilities exist. Check with Your Local Authorityor retailer for
recycling advice. Bemko Sp. z o.o.
ul. Bocznicowa 13
05-850 Jawczyce www.schelinger.eu
- Rated voltage, frequency.
- Rated current.
- Rated short circuit breaking capacity.
- Rated short circuit rated current.
- Rated switching capacity.
- Work characteristics.
- Rated surge voltage.
- International Protection Rating.
- Contamination degree.
- Rated insulation voltage.
- Mechanical strength.
- Caution, risk of electric shock.
- For internal use.
- Terminal capacity.
- Working temperature.
Security
Before mounting, read the instructions and disconnect the power supply.
Installation should be performed by a qualified user authorized to mount
electrical devices depending on the applicable regulations in a given country,
in accordance with the mounting diagram. Modifications to the product may
cause threat and loss of warranty. Use protection against frost when working
below 0 ° C. The function check should be performed once per month by pressing
the TEST button. Disconnecting the circuit means correct operation of the
device.
Maintenance
All maintenance work should be carried out after disconnecting the power supply. The product temperature may rise to an elevated value. Before commencing maintenance, make sure that the product temperature is safe to make it. Guarantee unrestricted air supply, do not cover the product. Use dry and delicate materials for cleaning. Do not use chemical agents. Product not adapted to work in an environment with unfavorable conditions, i.e. high dustiness / humidity, water, explosive zones, vibrations, chemical fumes.
Recommendations
Failure to follow the instructions in the manual may result in a fire,
electric shock, burns or other damage. Bemko sp. O.o. is not responsible for
failure to comply with the above recommendations. We also reserve the right
to make changes to the manual – the current version is available at
www.bemko.eu.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>