BARNES 7075 Bronco Rear Aluminum Control Arm Instruction Manual

: September 25, 2024
: BARNES

Table of Contents

7075 Bronco Rear Aluminum Control Arm
Contents of kit
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Bronco Rear Aluminum Control
Arm Installation Instructions

7075 Bronco Rear Aluminum Control Arm

Thank you for purchasing this product!
Installation Notes:

This kit is designed to be installed on 2021-current Broncos, it is not compatible with Bronco Sport models
Please refer to the factory service manual for removal of any factory components
A professional alignment is recommended after installation
Anti-seize compound is recommended during assembly of links
Factory hardware will be reused during installation

Tools required:

Various metric hand tools

Contents of kit

Bill Of Materials For B4WK13001

Step 1:
Assemble the heim joints, jam nuts, misalignment spacers, and links in the same order and orientation as the image below. The left-hand threads will be marked with a machined groove on the end of the link and on the hex of the jam nut for easy identification. Take care to install the misalignment spacers on the correct end of the link assembly. Step 2:
Measure and record the pinion angle and wheelbase of the Bronco with the existing control arms.
Step 3:
One at a time, remove the existing control arms and replace them with a new control arm. The control arm length can be adjusted if the heims are held stationary and the link is turned.
Adjust the links to move the axle to the position recorded in step 2. After installation of all four arms is complete a professional alignment is recommended.

Congratulations you have completed the installation!
Professional Services Disclaimer:
The content of all pages of this website (collectively, the “Website”), such as text, graphics, images, information and other material (collectively, “Content”) is for informational purposes only. Any information furnished on this Website is not intended nor implied to be automotive advice and is not intended to replace personal consultation with a qualified automotive service technician, mechanic, or similar automotive professional.
Barnes 4WD has not examined the Content for accuracy, timeliness, completeness, appropriateness, or helpfulness. Barnes 4WD does not endorse any specific tests, products, procedures, opinions, or other information that may be mentioned on this Website. Your reliance upon information and Content obtained by you at or through this Website is solely at your own risk. IN NO EVENT SHALL BARNES 4WD BE LIABLE OR OTHERWISE RESPONSIBLE FOR ANY DAMAGE OR INJURY (INCLUDING DEATH) TO YOU, OTHER PERSONS, OR PROPERTY ARISING FROM ANY USE OF ANY PRODUCT, INFORMATION, IDEA, OR INSTRUCTION CONTAINED IN THE CONTENT.
BARNES 4WD DOES NOT MAKE ANY REPRESENTATION OR WARRANTY, EXPRESS OR IMPLIED, AT LAW OR IN EQUITY, WITH RESPECT TO ANY PRODUCT FEATURED ON THE WEBSITE, INCLUDING WITHOUT LIMITATION WITH RESPECT TO MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE, VALUE, VALIDITY, OR ENFORCEABILITY, AND ANY AND ALL SUCH OTHER REPRESENTATIONS OR WARRANTIES ARE HEREBY EXPRESSLY DISCLAIMED.