BARNES 4SE-HL 15 HP 3 Inch Spherical Solids Handling User Manual
- May 15, 2024
- BARNES
Table of Contents
4SE-HL – 15 HP
3″ Spherical Solids Handling
Specifications
DISCHARGE: 4″ 125lb., horizontal flange
SPEED: 1750 RPM (Nominal)
IMPELLER:
- Design: 2 Vane, open with pump out vanes on back side, dynamically balanced, ISO G6.3
- Material: .Cast iron ASTM A-48, class 30
CORD ENTRY: 40 ft. (12.1 m) Cord. Epoxy sealed housing with secondary pressure
grommet for sealing and strain relief
MOTOR:
- Design: NEMA L- single phase, NEMA B – three phase torque curve, oil filled, squirrel cage induction
- Winding: Class F, class H rated magnet wire
- Service Factor: 1.15
SEAL:
- Design: Dual mechanical
- Material: Carbon/Ceramic/Buna-N Hardware – 300 series stainless
DIAPHRAGM: Buna-N
LIFTING BAIL: 304 Stainless steel
LIQUID TEMPERATURE: 104°F (40°C) Continuous
VOLUTE: Cast iron ASTM A-48, class 30
MOTOR HOUSING Cast iron ASTM A-48, class 30
SEAL PLATE: Cast iron ASTM A-48, class 30
SHAFT: 416 Stainless steel
SQUARE RINGS: Buna-N
HARDWARE: 300 Series stainless steel
PAINT: Air dry enamel (epoxy optional)
BEARINGS:
Upper Bearing:
- Design: Single row, ball, oil lubricated
- Load: Radial
Lower Bearing:
- Design: Single row, ball, oil lubricated
- Load: Radial
SINGLE PHASE: Capacitor start/capacitor run. Requires Barnes starter/panel
which includes capacitors and overload protection
THREE PHASE: Tri Voltage motor 200-230/460. Requires overload protection to be
included in control panel, VFD suitable
MOISTURE SENSOR: Normally open (N/O), requires relay in control panel
TEMPERATURE SENSOR: Normally Closed (N/C), Requires relay in control panel.
For three phase units ONLY
Curves
Pump HP | Impeller Dia mm (in.) |
---|---|
7.5 | 178 (7.00) |
11.3 | 203 (8.00) |
15 | 229 (9.00) |
Model Information
MODEL NO. | 4SE15034HL | 4SE15044HL | 4SE15054HL |
---|---|---|---|
PART NO. | 084646 | 84647 | 89317 |
HP | 15 | 15 | 15 |
VOLT/PH | 230/3 | 460/3 | 575/3 |
Hz | 60 | 60 | 60 |
RPM (nom) | 1750 | 1750 | 1750 |
NEMA START CODE | D | D | D |
FULL LOAD AMPS | 38 | 19 | 15.2 |
LOCKED ROTOR AMPS | 160 | 80 | 64 |
CORD SIZE | 06-Apr | 06-Apr | 08-Apr |
CORD TYPE | SOW | SOW | SOW |
CORD O.D INCH (mm) | 1.06 (27) | 1.06 (27) | 0.830 (21) |
Drawing
© 2024 Crane Pumps & Systems
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>