Foshan DLT433RC Wireless Remote Control Instruction Manual
- September 24, 2024
- Foshan
Table of Contents
Foshan DLT433RC Wireless Remote Control
Product Usage Instructions
- Open the battery compartment of the remote control and insert 2 AAA button batteries, ensuring correct polarity.
- Press the power button to turn on the remote control. The standby light should indicate that it is ready for use.
- Point the remote control towards the target device and press the desired buttons to transmit commands. Ensure there are no obstructions between the remote and the device.
- To conserve battery life, remember to turn off the remote control when not in use by pressing the power button again.
FAQ
- Q: How do I know if the remote control is working?
- A: Check if the standby light illuminates when buttons are pressed. You can also test the remote by pointing it at a digital camera or smartphone camera and pressing buttons while looking at the screen for a flashing light, indicating transmission.
- Q: What should I do if the remote control stops working?
- A: Ensure the batteries are not depleted and properly inserted. Try replacing the batteries with new ones. If issues persist, contact customer support for further assistance.
Pictures of objects
Parameters
- Product Model: DLT433RC
- Operating voltage: DC3V ( 1.5V*2 AAA button battery)
- Operating current: less than 20MA when transmitting
- Operating frequency: 433.92MHZ
- Modulation mode: OOK
- Standby current: less than 5UA
- Size: 9840.511mm
- Product quality: 24.5g
Instructions for operation
- Press the PLAY button, send signal, open the machine, release to stop sending.
- Press the+key, send signal,speed+, release to stop sending.
- Press the-key, send signal,speed-, release to stop sending.
Application production scene
- The treadmill remote control
- remote control toys.
- Smart furniture. , etc.
- Wireless remote control
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
Warning
This device has been tested and found to comply with the limits for a Class B
digital device, according to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>