Foshan Shunde Yushengjia Electrical AD-0540LT-DM DC Ceiling Fan Remote Control Instructions
- June 5, 2024
- Foshan Shunde Yushengjia Electrical
Table of Contents
INSTRUCTION FOR DC MOTOR CEILING FAN REMOTE CONTROL
Instructions
INNOVATION•ENERGY-SAVING•FUTURE
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user s authority to
operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
WIRING SCHEMATIC DIAGRAM FOR RECEIVER
POWER PARAMETER LIST
| Voltage | Fan(max ) | Light(max.) |
|---|---|---|
| 220-240V | 50W | 85W |
| 120V | 50W | 85W |
Adopt RF wireless digit emission technique, biunique controlled, the coincident code rate is less than one-millionth.(Emitter and receiver must be sent back to the factory for maintenance if damaged.) The receiver can be controlled by any angle of the emitter in prescriptive space, unrestricted by direction. With the memory function, the controller can save the status( light and direction ) while the supply power OFF and resume to the original after reloading the power supply.
FUNCTION INSTRUCTION OF EMITTER
- Fan ON/OFF
- Light ON/OFF
- Speed of the fan 1 (Clow speed~ 5 high speed)
- Brightness adjust Turn down the Lightness
- Brightness adjust Turn up the Lightness
- The direction of the fan(Reverse switch)
- Timing control of the fan
- LED indicated light
KINDLY REMINDERS
- Learning code matching mode is used between emitter and receiver. Turn “ON” the supply power within 30 seconds and press the emitter’s ” ‘ button for 5 seconds, it can load normally after hearing a long sound “bee”, which means learning successfully and it can work normally. (PS: Learning mode is not accepted after turning “ON” the supply power for 30 seconds)
- When the emitter cannot control the receiver, please check whether the battery switch touching normally or not, correction of the positive and negative, full or empty of the power.
- When the emitter cannot control the receiver, please check is there any existence of similar remote-controlled products nearby, then check whether they work, because a remote-controlled product with the same frequency will disturb each other.
- The low voltage of the battery will affect the sensitivity of the emitter and the signal reception accordingly (the indicated light will be dimmed when the battery gets low voltage), must replace if the battery is getting low voltage.
- Please take out the battery from the emitter when left unused for a long time.
- For the maximum load of lighting see the above”POWER PARAMETER LIST” PS: please connect the ground wire correctly, otherwise, it may cause the light to micro-light or flash
- When installing the fan, the fan ceiling cover doesn’t press the antenna(or other wire), it is easy to break down the wire and short-circuited.
AD-0540LT-DM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>