Foshan Huazhao Electronics HZ50 LED Whip Light User Guide
- June 2, 2024
- Foshan Huazhao Electronics
Table of Contents
Foshan Huazhao Electronics HZ50 LED Whip Light
Includes
Box comes with (single pc)
Box comes with (combo set)
Warning
It is recommended that this installation be performed by a licensed
professional. The improper installation of this kit will void all warranties
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND
OPERATING THIS LED WHIP
Instructions
Step 1 Mount Up
- Remove the bottom nut and the spring washer on the bottom of your quick-release mount
- Mount the LED WHIP into any open ” bolt mount on your vehicle. Make sure the flat washer is inbetween the whip and the mount
- Place the spring washer underneath the mount and then rescrew the bottom nut
- Have a pair? Go for round 2 and mount the 2nd whip the same way
Step 2 Get wired!
-
Grab your battery cord and connect it to the bottom hanging cord on your LED WHIP
-
Have a pair? Connect the 3-prong plug coming out the side of the master LED WHIP to the plug coming from the slave LED WHIP.
Note: The slave LED VWHIP cannot function without being connected to the master LED WHIP -
Feed the power cord through to your vehicle battery
-
Connect the terminal wire to the Positive(+) and Negative() terminals of your vehicle battery
-
Hide any extra wiring with zip ties
Step 3
When whip is not attached to base, using supplied cap to keep dirt and debris
out of connector
Step 4
Using the flag mounts to secure flag to the whip
SPECA One PC LED Whip
SPECB One Pair LED Whips
RF Remote controller
FCC STATEMENT
FCC Warning Statement: Changes or modifications to this unit not expresslyapproved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested andfoundto comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and usedinaccordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or moreof the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different fromthat towhich the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
tothefollowing two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. FCC Radiation
Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
Thedevice can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>