Foshan Pengxue Trading XD200 Bluetooth Speaker User Manual
- June 5, 2024
- Foshan Pengxue Trading
Table of Contents
Foshan Pengxue Trading XD200 Bluetooth Speaker
Instructions for Use
- Power ON/OFF
- Use the “OFF/ON” button to turn the soundbar ON/OFF. When turned on, the multicolor LEDs will be activated automatically and the first function mode the soundbar will enter is the “BT mode”.
- BT Association
- To connect your device to the soundbar without the aid of a cable, activate Bluetooth on your device and select “TM-SP047” from the devices found. An acoustic signal will notify you of the connection.
- Change mode
- To change the playback mode, press the “M” button on the front of the soundbar until you reach the chosen playback mode.
- BT mode
- In this mode, it will be possible to listen to the music played on your device, but also to answer calls in hands-free mode.
- To answer the calls, press once on the “play” button. To hang up, press the button again. To reject an incoming call, press and hold the “play” button. the desired station.
- To tune to radio stations, press and hold the “play” button. At the end of the search, the speaker will automatically memorize the frequencies found.
- Press the “play” button to mute the audio. Press it again to turn the volume back on.
- SD card mode
- Once the SD Card is inserted, the soundbar will automatically start playing the songs contained in it.
- Aux mode
- Once the AUX cable is inserted, the soundbar will automatically start playing the songs played on your device.
- Raise / Lower the volume
- To raise the volume, press and hold the “+” button until the volume reaches the desired tone.
- To lower the volume, press and hold the “-” button until the volume reaches the desired tone.
- Pause/ Play
- Press the “play” button to pause the song. Press it again to -resume playback. Function not available with FM Radio.
- Previous/ Next track
- Press the “-” button once to go back to the previous song or to play the song from the beginning.
- Press the “+” button once to play the next song.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>