Foshan Jianfeng Electronic Technology JF018 Receiver In Ceiling Fan Installation Guide
- June 5, 2024
- Foshan Jianfeng Electronic Technology
Table of Contents
Foshan Jianfeng Electronic Technology JF018 Receiver In Ceiling Fan
INSTALLING RECEIVER IN CEILING FAN
Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by removing fuse or switching off
circuit breaker.
Do not use with solid-state fans. Electrical wire must meet all local and
national electrical code requirements.
Electrical rating: 110v-120V 60Hz
MAX. Motor amps: 1.0A
MAX. Light watts: 180W
Otherwise, power can cause serious injury or death.
Installing receiver in fan:
- Remove power from the circuit.
- Remove ceiling fan canopy from the mounting bracket.
- Disconnect existing wiring between ceiling fan and Supply in electrical junction box.
- Make connections as follows, using the wire nuts supplied:
CONNECT TO
- Green fan wire … .Bare supply wire
- Red receiver wire(AC IN L) … Red or Black supply wire
- White receiver wire(AC IN N) … White supply wire
- White receiver wire(TO MOTOR N) … .White fan wire
- Black receiver wire(TO MOTOR L) … .Black fan wire
- Blue receiver wire(FOR LIGHT) …. Blue light wire
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>