Foshan Shunde Fengyun Electric Appliance FYD-3598 DC Fan Lamp Remote Control User Manual
- June 4, 2024
- Foshan Shunde Fengyun Electric Appliance
Table of Contents
Foshan Shunde Fengyun Electric Appliance FYD-3598 DC Fan Lamp Remote Control
Remote Control
① ON/OFF the Light
② ON/OFF the Fan
③ Speed of the Fan
④ Reverse switch
⑤ Natural wind
⑥ Temp erature control
⑦ Anti-theft Light
⑧ Delay closing Fan and Light
⑨ Timing control
Note: The remote works with battery 1.5V AAA x 2pcs (not included)
Instruction of transmitter and receiver
-
If the remote control can’t control the fan, please reset the matching mode between transmitter and receiver.
Switch on electricity for the fan, make transmitter point to receiver, and press the ON/OFF Fan button on the remote control until hearing “bee”, the match is done successfully.
Note: the match has to be done within 10 seconds after the power electricity has been given to FAN, otherwise the fan will skip the matching mode. -
Please check the following cases if the match fails:?
– check battery polarity and connection in transmitter;
– if there is any other similar remote control nearby, because the same work frequency of remote controls will interfere each other. -
Please take battery out from transmitter and remote control, if the fan won’t be used for a long period.
-
Don’t squeeze signal wires, it would damage them and cause short circuit.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonableprotection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
theinstructions, may cause harmful interference to radio communications.
However, there is noguarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which canbedetermined by turning the equipment off and on, the user
is encouraged to try to correct theinterference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices has been evaluated to meet general RF exposure requirement，the device canbeused in portable exposure condition without estriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>