ecoer Morley EEV Kit Green and Smart Installation Guide
- September 18, 2024
- ecoer
Table of Contents
ecoer Morley EEV Kit Green and Smart
EEV Kit
Danger!
Turn off the system’s power and wait until it is fully powered down before
proceeding with this installation.
Installation Guidance
Step 1: Remove the outdoor unit’s electric control box cover and use a screwdriver to remove the black protective cover on the motherboard.
Step 2: Find the EEV interface CN13 on the board, and then unplug the EEV line from mainboard.
Step 3: Connect the unplugged EEV line to the EEV Kit CN13 OUT port, and then insert the EEV Kit into the original EEV Interface on the mainboard.
Step 4: Connect the CN3 line from the EEV Kit to the CN3 interface on the
mainboard, and the entire installation process is successfully completed.
Step 5: When installation is complete, reinstall the black protective
cover.
Notice:
During the installation process, the power supply must be disconnected before
installation operations can be performed. Pay attention to electrical safety.