dyras FGD-4B Table Fan Instruction Manual

: September 17, 2024
: dyras

Table of Contents

dyras FGD-4B Table Fan
IMPORTANT SAFEGUARDS
PRODUCT STRUCTURE
PREPARATION
OPERATION

dyras FGD-4B Table Fan

IMPORTANT SAFEGUARDS

Please save these instructions for further use!

Use as per the rating voltage!
Do not repair or remake the appliance by yourself. It should be repaired by the repairmen.
Do not operate the appliance with wet hands, in order to avoid damage.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
When the appliance is not in use, switch it off and unplug it.
Do not use the appliance near explosive and combustible gas.
Use the appliance only on a flat surface.
Do not use outdoors.
Do not turnover the appliance. Unplug the USB power supply if it is toppled over and there have some water in the device. Dry the device before use.
Clean the appearance with a lightly damp cloth. It can clean with neutral detergents. Do not rinse with water.
Do not knock or shake the device when use, otherwise it may cause stop.
Do not use the appliance in the immediate surrounding of a bath, a shower or a swimming pool.
This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children are not allowed to play with the device! Children should not clean the appliance unattended!
Do not place this appliance on any flooring that may be marked or damaged by vibration of appliances.

PRODUCT STRUCTURE

Power switch
Foot pad

PREPARATION

Install the 3 foot pads.
Place the fan on a firm, level surface and use USB cord to connect any power supply (USB power block not included).

OPERATION

Settings: Off/Fan
3. FAN: Switch to the “_”, the fan will rotate.
4. OFF: Switch to the “O”, the fan will shut down.

PRODUCT SPECIFICATIONS

Power Mode: USB
Voltage: DC 5V, Power: 3W
Applicable area: 2-4 m2
Operation mode: Mechanical
Air supply mode: Rotary vane

CLEANING AND MAINTENANCE

Always disconnect the fan from USB power supply before cleaning.
Avoid contact with moving fan parts.
Use only a soft damp cloth to clean the fan, the grill and the blades.
DO NOT immerse the fan in water and never allow water to drip into the motor housing.
Never spray the appliance with liquids or submerge it in water or other liquid.
DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
Ensure that the fan is switched off from the supply mains before removing the grill.

CAUTION : The fan blades may have sharp edges. Handle with extreme care.

STORAGE
Store the fan in a cool, dry location when not in use.
To prevent dust and dirt build-up, use the original packaging to repack the unit.

WASTE MANAGEMENT

Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Manufacturer/Importer: Vöröskő Kft., 8200 Veszprém, Pápai str. 36.

CE SYMBOL
The mark is intended to indicate that the product complies with the relevant European Union standards and can be freely marketed in the European Union.

No parts of the content (including logos, design, photos, text, colour scheme arrangements, etc.) may be reproduced, reused or redistributed for any purpose whatsoever, or distributed to a third party for such purposes, without the written permission of Dyras Europe Kft.
“dyras” is a registered trademark of Dyras Europe Kft.

www.dyras.eu