Mous A788 MagSafe Compatible 3In1 Portable Charger Instruction Manual

Mous A788 MagSafe Compatible 3In1 Portable Charger

Before Use

• Please read this guide before using the device in order to ensure safe and proper use.
• Please consult your device packaging to determine whether this product is compatible with your device.
• Your consumer rights are governed by the law of the country in which you purchased the product.
  Please contact your service provider for more information.

What’s In The Box?

• MagSafe Compatible 3-in-1 Portable Charger
• USB-C Charging Cable

How To Set Up Your MagSafe Compatible 3-in-1 Portable Charger

1. Carefully remove the portable charger and the USB-C cable from the packaging.
2. Plug one end of the USB-C cable into the charger, and the other end into a power adaptor that can deliver at least 24 watts of power for optimal performance. If you’re not sure about your adaptor’s power rating, please refer to its documentation or consult the manufacturer.
3. Plug the power adaptor into an electrical outlet.
4. Check that the LED light on the charger flashes twice in a bright green colour. The green light will remain on and confirms that the charger is powered and working correctly.
5. Place your MagSafe compatible device on the MagSafe module, ensuring that the device is properly aligned with the magnetie conneetion. For AirPods or other small deviees that can charge wirelessly, place them on the wireless earbuds module to begin charging.
6. The LED light on the charger will “breathe” green – slowly transitioning between on and off – while the MagSafe module or wireless earbuds charging module is charging your device.
7. The LED light will remain solid green when the devices are fully charged.
8. When you’re done charging your devices, remove them from the portable charger.

Understanding The LED Light On Your MagSafe Compatible 3-in-1 Portable

Charger

The LED light on your MagSafe Compatible 3-in-1 Portable Charger provides important information about the charging status of your devices. Here’s what you need to know:

• Power On

  • The LED light turns on when the power adaptor is plugged in and the cable is attached.
  • If the power adaptor is 24W or greater, the LED light flashes twice in green.
  • If the power adaptor you are using is less than 24W, the LED light will still flash twice in green, but the charger won’t perform correctly. We recommend using a 24W or higher power adaptor.
  • When the MagSafe Compatible 3-in-1 Portable Charger is in standby mode, the LED light is not lit.

• MagSafe Charging

  • The LED light “breathes” green when a device is placed on the MagSafe module.
  • When the device is fully charged, the LED light stays solid green.

• Wireless Earbuds Charger

  • The LED light “breathes” green when a device is placed on the earbuds charger.
  • When the device is fully charged, the LED stays solid green.

• Non-Magnetic Alignment

  • Place smaller devices in the centre of the wireless earbuds groove.
  • For slightly larger devices, rest them on the top of the wireless earbuds groove. Note that a large secondary device may impede use of the Apple Watch charger.

• Apple Watch Charging
  There is no LED feedback when a watch is placed on the Apple Watch charger. The feedback is provided by the device itself.

• Troubleshooting: Over-voltage protection and low-voltage protection
  If the LED lights flickers continuously, over-voltage or low-voltage protection has activated, which suggests a low-quality power adaptor. Try using a different one.

• Troubleshooting: Foreign Object Detection
  If the LED continuously flashes green, check that the device is correctly aligned and that there are no metal objects between the device and the charger.

Important Safety Instructions – Warning

Read all instructions and warnings prior to using this product. Improper use of this product may result in product damage, excess heat, toxic fumes, fire or explosion, for which damages you (“Purchaser”), and not Mous Products Ltd. (“Manufacturer”) are responsible.

• Do not place metal objects between phone and charger as the charger may get very hot.
•  Do not use or store devices in high-temperature environments, including heat caused by intense sunlight or other forms of heat, as this may reduce charge efficiency or reduce lifespan of the product.
• Do not place product in fire or other excessively hot environments. Exposure to fire or extremely high heat may cause explosion.
• This product is fitted with magnets. Pacemaker and ICD users are advised not to position the MagSafe Compatible 3-in-1 Portable Charger within 20cm radius of their implanted device as it may cause interference.
• Do not expose the MagSafe Compatible 3-in-1 Portable Charger to water. Exposure to water may result in short circuiting. If short circuiting occurs immediately turn off at the wall.
• Do not use the MagSafe Compatible 3-in -1 Portable Charger in excess of its output rating. Overloading outputs above rating may result in a risk of fire or injury to persons.
• Do not disassemble this product or attempt to repurpose or modify it in any manner.
• Do not attempt to replace any part of this device. Any modification or disassemblement may result in a void of warranty.
•  Use of a power supply or charger not recommended by Mous may result in a risk of fire or injury to persons.
• If this device is accessible to or may be used by a minor, the purchasing adult agrees to be solely responsible for providing supervision, instruction, and warnings. Purchaser agrees to defend, indemnify, and hold Manufacturer harmless for any claims or damages arising from unintended use or misuse by a minor.
• All products have gone through a thorough quality assurance inspection. If you find that your device is  excessively hot, is emitting odour, is deformed, abraded, cut, or is experiencing or demonstrating an abnormal phenomenon, immediately stop all product use and contact Mous.
• Switch off the MagSafe Compatible 3-in-1 Portable Charger when not in use.
• To disconnect the MagSafe Compatible 3-in-1 Portable Charger from line voltage, pull the AC Adapter from the AC outlet.
• To comply with FCC RF exposure compliance requirements, the MagSafe Compatible 3-in-1 Portable Charger must be used with a separation distance of at least 20cm from all persons.

Legal

This product is meant for use only in conjunction with the appropriate device. Please consult your device packaging to determine whether this product is compatible with your particular device. Manufacturer is not responsible for any damages to any device incurred through the use of this product. Manufacturer shall not in any way be liable to you or to any third party for any damages you or any third party may suffer as a result of use, intended or unintended, or misuse of this product in conjunction with any device or accessory other than the appropriate device for which this product is designed. Manufacturer will not be responsible for any damages you or any third party may suffer as a result of misuse of this product as outlined above. Purchaser agrees to defend, indemnify, and hold Manufacturer harmless for any claims or damages arising from unintended use or misuse, including use. with an unintended device. Mous is a trademark of Mous Products Ltd. Apple, AirPods, Apple Watch and MagSafe are trademarks of Apple Inc.

Statement of Compliance

Mous declares that the radio equipment wireless charging base is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.mous.co

FCC Statement

• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
  1. This device may not cause harmful interference
  2. this device must accept any interference received, including interference that may cause undesired operation.
• Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced technician for help.

FCC Radiation Exposure Statement

• The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
• This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
• To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be used with certified peripherals and shielded cables. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may result in interference to radio or reception.

PRODUCT SPECIFICATION

• Technology WPT
• Operating Frequency Range UKEU only: 115KHz-205kH2, 300-350kHz
• Maximum field strength 0.82dBA/m/@10m)
• Manufacturer Dongguan OPAQI Electronics Technology Co. Ltd
• Manufacturer address No.2, Xifu Street, Lin Village, Tangxia Town, Dongguan, China

IC Statement

• Radio Standards Specification RSS-Gen, issue 5.
• This device contains license-exempt transmitters)/ receivers) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSSs). Operation is subject to the following two conditions:
  • This device may not cause interference,
  • This device must accept any interference, including interference that may cause undesired operation of the device.

IC RF Exposure Statement

The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 10cm between the radiator and your body.

WEEE Declaration

All of our products are marked with the WEEE symbol; this indicates that this product must NOT be disposed of with other waste. Instead it is the user’s responsibility to dispose of their waste electrical and electronic equipment by handing it over to an approved re-processor, or by returning it to Mous for reprocessing. For more information about where you can send your waste equipment for recycling, please visit www.mous.co

Warranty

At Mous, we are dedicated to making high quality products that last. To give you peace of mind, this product is warranted for 1 year from the date of delivery. For full details regarding warranty terms and exclusions, please visit: www.mous.co/warranty. This warranty does not affect any statutory rights that you may be entitled to. Keep a copy of your purchase receipt as proof of purchase.

Customer Service

Need some extra help? Do get in touch with us at www.mous.co/pages/help

ABOUT COMPANY

• Company Name: Sea&Mew
• Consulting GmbH
• Address: Mittenhuber Straße 4,
• 92318 Neumarkt
• Email: compliance.eu@outlook.com
• Contact Person: Yuan Li

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>