ANKER A2670 312 Charger User Manual
- June 12, 2024
- Anker
Table of Contents
ANKER A2670 312 Charger
The Anker 312 Charger is a 20W charger for charging your USB-C-enabled devices. Please read all the instructions before using the product.
Product Information
- Model: 3 SERIES
- Charger Type: Wall Charger
- Input: AC (alternating current)
- Output : USB-C (universal serial bus type C)
- Power: 20W
Usage Instructions
- Plug the Anker 312 Charger into an AC wall outlet.
- Connect your USB-C-enabled device to the charger using a USB-C cable.
- Your device will start charging automatically.
- If you experience any issues with the product, please get in touch with Anker customer support for assistance.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Attention
Read all the instructions before using the product.
- The product is designed for use with IT equipment only.
- Naked flame sources, such as candles, must not be placed on the product.
- The disconnection from line voltage is made by AC plug.
- In case of broken plugs, the product must be disposed of.
- If you want to clean the product, only use a dry cloth or brush.
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- The power supply is not intended to be repaired by service personnel in case of failure or component defect (the product can be disposed of).
| Input | 100-240V~ 0.6A 50-60Hz |
|---|---|
| Output | 152VV 3A1./697VA 2.22A/ |
| Average Active Efficiency | 86.5% |
| Efficiency at Low Load (10%) | 74.07% |
| No-Load Power Consumption | 0.07W |
| --- | --- |
| Recommended Oper- ating Temperature | 0-25℃ / 32-77 ℉ |
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party (for FCC matters only).
- Company Name: Fantasia Trading LLC
- Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
- Telephone: +1 (800) 988 79733
IC Statement
This digital apparatus complies with CAN ICES-003(B)/NMB- 003(B).
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance
with Directive 2014/35/EU & 2014/30/EU & 2011/65/EU & 2009/125/EC &
2019/1782/EU. The full text of the EU Declaration of Conformity is available
at the following Internet address: https://www.anker.com. Hereby, Anker
Innovations Limited declares that this product is in compliance with
Electrical Equipment (Safety) Regulations 2016 & Electromagnetic Compatibility
Regulations 2016 & The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012 & The Ecodesign for
Energy-Related Products Regulations 2010. The full text of the GB declaration
of conformity is available at the following internet address:
https://www.anker.com..
Customer Service
- 18-month limited warranty
- Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty
- Lifetime technical support
- support@anker.com.
- support.mea@anker.com (For Middle East and Africa Only)
- (US/CA) +1 (800)988 7973
- (UK) +44 (0) 1604 936200
- (DE) +49 (0) 69 9579 7960 (Middle East & Africa) +971 42428633
- (UAE) +971 8000320817
- (KSA) +966 8008500030
- (Kuwait) +965 22069086
- For tutorial videos, FAQs, manuals, and more information,
- please visit: https://support.anker.com.
- Or scan the QR code below:
- Product Number: A2670
- 51005003842 V01