PROLED XL-L7MA0xx0608 Actor Downlight Installation Guide
- September 18, 2024
- PROLED
Table of Contents
Installation manual
PROLED DOWNLIGHT
ACTOR XS / S / M / L / XL – L7MA0xx0608
Characteristics:
- SMD LED Warm White or Neutral White selectable
- Power consumption selectable 5,5 W / 8,0 W (XS), 14 W / 19 W (M / L), 15 W / 21 W (L / XL)
- Metall housing round
- Mounting ring colour White
- Reflector ring colour silver
- Beam angle 75° (XS), 80° (S / M), 90° / 100° (L / XL)
- Driver 220-240 VAC or 180-260 VDC
- Not dimmable
- Operating temperature range -10° C till +45° C
- CE compliant with applicable European directives
Warning:
- For indoor use only or secured wet room (IP54)
- Please ensure that the packaging is disposed of in a safe environment
- If cable is defected, do not use luminaire
- We do recommend that a qualified electrician should be used to install the products
- Do not look at the lighted lamp directly
Safety indices:
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any lights installed without observing European safety directives. The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as manufacturer. Do not cover lamps with heatinsulating materials. For indoor use only. Protection class IP54.
Installation:
Please follow the sequence of installation step by step.
- Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
- Connect driver to power supply 230VAC or 180-260 VDC
- Make sure all connections are tight with no loose strands
- Ensure fire regulations are not breached when fitting your lights
- If you are in any doubt regarding these instructions, consult a qualified electrician
Remark to energy efficiency class of the light source:
This product contains a light source of energy efficiency class C:
Attention:
This product counts as „containing product“ according to directive (EU)
2019/2020 and (EU) 2019/2015.
The light source is part of the containing product. A separation of the light
source and the containing product using commonly available tools is possible
with this product.
Replacement of the light source, using commonly available tools, is possible
with this product.
The light source can be separated for testing purposes.
Installation and commissioning may only be performed by qualifies persons.
National installation regulations must be observed.
Luminiares must be disconnected from mains before any work.
03.24 Technical amendments reserved
MBN GmbH, Balthasar-Schaller-Str. 3,
86316 Friedberg – Germany
www.proled.com