dyras SF-1843B 18 Inch Stand Fan Instruction Manual
- September 14, 2024
- dyras
Table of Contents
dyras SF-1843B 18-inch Stand Fan
Product Specifications
- Rated voltage: 220-240V
- Frequency: 50-60 Hz
- Power: Max. 75W
- Class: II
Product Structure
- Front guard
- Blade cap
- Fan blade
- Plastic mounting nut
- Rear grille
- Motor shaft
- Oscillation knob
- Motor housing
- Switch box
- Tilt adjuster
- The inner tube (inside the outer tube)
- Height adjustment collar
- Outer tube
- Base screws (4X)
- Round base cover
- Plug
- Fixing lugs
Product Usage Instructions
Preparation
- Place the outer tube on the round base cover and screw it.
- Unscrew the plastic mounting nut from the motor housing.
- Place the rear grille into the motor housing and screw back the plastic mounting nut.
- Place the fan blade and the blade cap on the motor shaft. Make sure to push the fan blade to the point of impact and fit it into the crossbar.
- Place the front guard. Make sure that the screw hole at the bottom fits the rear grille. Snap in the lugs and screw in.
- Place the height with the height adjustment collar.
Please carefully read the instructions before using!
IMPORTANT SAFEGUARDS
Please save these instructions for further use!
- Incorrect operation and improper handling can lead to faults on the device and injuries to the user.
- In the event of improper use or incorrect handling, no liability can be accepted for any damage that may occur.
- Before you put the plug into the socket, please check that the type of current and mains voltage correspond to the instructions on the nameplate of the appliance.
- Do not immerse the unit or mains plug in water or other liquids due to the risk of electric shock! However, if this should occur, remove the mains plug immediately and then have the unit checked by an expert before using it again.
- Do not operate the device if the mains cable or the mains plug shows signs of damage if the device has fallen on the floor, or has been otherwise damaged. In such cases take the device to a specialist for checking and repair, if necessary.
- Never remove the mains plug from the socket by pulling on the mains cable, or with wet hands.
- Ensure that the mains cable does not hang over sharp edges or allow it to become trapped.
- Keep the appliance away from dampness, and protect it from splashes.
- Keep the appliance away from hot objects (e.g. hotplates) and open flames.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, nor lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- The machine should not be operated using an external timer switch or using a separate system with a remote control.
- Use the appliance on a flat, dry, and heat resistant surface.
- This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops,
- offices and other working environments;
- by clients in hotels, motels and other residential type environment;
- bed and breakfast type environments.
- Never leave the device unattended during use.
- Do not store or operate the appliance in the open air.
- Keep the appliance in a dry place, inaccessible to children (in this packaging).
- Never put fingers or any other objects through the grilles (fan guards) when the fan is running.
- Never operate the product without the grilles (fan guards) in place, as serious personal injury may result.
- The appliance must be assembled completely before use.
- Watch out for long hair! It can be caught in the fan owing to the air turbulence.
- Do not point the airflow to the people for a long time.
- Ensure that the fan is switched off from the supply mains before removing the guard.
PRODUCT SPECIFICATIONS
- Rated voltage 220-240V
- Frequency 50-60 Hz
- Power max. 75W
- Class II.
II class protection: a product in which protection against electric shock is provided not only through basic insulation but also double or reinforced insulation.
PRODUCT STRUCTURE
-
Front guard
-
Blade cap
-
Fan blade
-
Plastic mounting nut
-
Rear grille
-
Motor shaft
-
Oscillation knob
-
Motor housing
-
Switch box
-
Tilt adjuster
-
The inner tube (inside the outer tube)
-
Height adjustment collar
-
Outer tube
-
Base screws 4X
-
Round base cover
-
Plug
-
Fixing lugs
-
High speed
-
Middle speed
-
Low speed
-
Sleep mode
-
Nature mode
-
On/Off button
-
Speed button
-
Timer button
-
Light on/Light off button
-
Mode button
-
4 hours timer
-
2 hours timer
-
1 hours timer
-
0,5 hours timer
-
Indicator light
PREPARATION
- Place the outer tube on the round base cover and screw it (Img. 1).
- Unscrew the plastic mounting nut from motor housing (Img. 2).
- Place the rear grille into the motor housing and screw back the plastic mounting nut (Img. 3).
- Place the fan blade and the blade cap tonthe motor shaft. Make sure to push the fan blade to the point of impact and fit it into the crossbar (Img. 4)
- Place the front guard. Make sure that the screw hole at the bottom fits the rear grille. Snap in the lugs (17) and screw in (Img. 5).
- Place the height with the height adjustment collar (Img. 6).
OPERATION
- Make sure you read all safety instructions before first use.
- Plug the cord into a power outlet and turn on the power main switch.
- Use the Speed control button to set the desired speed.
- To turn the fan in swing mode, press the oscillation knob to move it to a downward position. Pull the knob to the up position to stop the swing mode.
- Speed: The fan can operate at 3-speed settings: low speed, mid-speed, or high speed.
- Timer: The fan’s working time can be set between 0,5 hours to 7,5 hours by pressing the timer button and choosing the right time.
- Mode : You can choose between Nature mode or Sleep mode.
- Nature mode : pulsating movement, gives a sense of the movement of fresh air when the window is opened
- Sleep mode: Provides reduced performance to help you get a good night’s sleep.
- Light: pushing the light button can turn on/off the LED.
CLEANING AND MAINTENANCE
- Attention: Turn the device off and unplug it before cleaning!
- Always disconnect the fan from h ain socket before cleaning.
- Avoid contact with moving fan parts.
- Use only a soft damp cloth to clean the fan.
- DO NOT immerse the fan in water and never allow water to drip into the motor housing.
- Never spray the appliance with liquids or submerge it in water or other liquid.
- DO NOT use gasoline, paint thinner, or other chemicals to clean the fan.
- Ensure that the fan is switched off from the supply mains before removing the grill.
- Clean the fan blade and grills with a soft damp cloth.
CAUTION : The fan blade may have sharp edges. Handle with extreme care.
STORAGE
- Store the fan in a cool, dry location when not in use.
- To prevent dust and dirt build-up, use the original packaging to repack the unit.
WASTE MANAGEMENT
Correct Disposal of this product: This marking indicates that this
product should not be disposed of with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmentally safe recycling.
CE SYMBOL: The mark is intended to indicate that the product complies with the relevant European Union standards and can be freely marketed in the European Union.
No parts of the content (including logos, design, photos, text, color scheme arrangements, etc.) may be reproduced, reused, or redistributed for any purpose whatsoever, or distributed to a third party for such purposes, without the written permission of Dyras Europe Kft. “dyras” is a registered trademark of Dyras Europe Kft.
FAQ
Q: Can this stand fan be used outdoors?
A: This stand fan is designed for indoor use only and should be kept away from
damp areas or outdoor conditions.
Q: What should I do if the main cable shows signs of damage?
A: If the mains cable or plug shows signs of damage do not operate the fan and
take it to a specialist for checking and repair if necessary.
Q: Can children use this stand fan?
A: This appliance is not intended for use by persons, including children,
without adult supervision.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>