FiiK Division Electric Scooter Instruction Manual

FiiK Division Electric Scooter

SAFETY PRECAUTIONS

Please take note of the below safety information before riding your scooter.

1. Always wear your helmet, knee pads, elbow pads and wrist guards along with appropriate flat-soled shoes in case of an accident.
2. This scooter is recommended for users over the age of 12.
3. Observe all traffic rules and regulations and be aware of local laws on the use of electric scooters.
4. Do not ride at night
5. Always ride within the limits of your capability and build up from the slow speed settings first.
6. Do not charge the scooter in abnormally hot, cold, or wet conditions.
7. Do not charge your scooter in a location that could be ignored or forgotten.
8. Do not ride the scooter in wet conditions as this can cause electrical components to short circuit and will not be covered by warranty.

FOLDING INSTRUCTIONS

• a. To open the folding bracket, press down the lever until the folding mechanism is disengaged.
• b. Lower down the stem until the folding mechanism clicks into place, a “click” sound will be heard.
  ( Warning: Make sure your fingers are clear of the folding or pinch point)

CHARGING

1. Ensure the Urban is fully charged before use
2. To charge, plug the charger into the wall socket and turn it on. This should show a green light on the charger.
3. Plug the charger into the scooter’s charge port located at the front of the deck. The light will turn red to indicate charging.
4. Once the scooter is fully charged the light will turn green. Unplug the charger once charging is complete
5. Only use the supplied charger to charge this scooter. An incorrect charger can damage the battery
6. If the scooter is unused for an extended period, please top up the charge every month to protect the battery.

SCOOTER ASSEMBLY

Full video available on website www.flik.com

HOW TO ASSEMBLE

Step 1. Press the button, and then raise the stem until the folding mechanism is engaged – a “click” sound will be heard.
( Warning: Make sure your fingers are clear of the folding or pinch point)

Step 2. Screw out the Top Clamp, place the handlebar set onto the top of the stem, and put the Top Clamp onto the handlebar
( Note: Align the raised point into the hole of the handlebar), screw in the bolts and then tighten them completely.

SCOOTER OPERATION

1. Put one of your feet onto the Sensor pad and kick the scooter to give it a minimum speed of 5km/h, then the power will kick in.
2. If you want to slow down, tap the brake pad and this will shut off the throttle, release the pad to re-activate the throttle.
3. If you want to stop completely, keep pressing the brake pad until the scooter comes to a stop.
4. In case of emergency, you can jump off the scooter, and the Urban will stop running immediately.

FREE ROLLING MODE

The Urban has a free rolling mode. When the battery power drops below 10% it will enter free-rolling mode automatically and will not provide any power. In this mode, the motor has zero resistance, and the user can use it as regular non-electric kick scooter. This will last for around 10 minutes until the motor is powered off completely.

MAINTENANCE AND SERVICE

BATTERY
The battery is a 36V 93.6Wh 18650 Lithium lon pack (LiFePO4).

REAR HUB MOTOR
If the rubber on the rear hub motor tread wears down to less than 1mm, it is time to replace the tyre.

WHEEL BEARINGS
If excess water or dirt get into the wheel bearings, they can start to make a grinding or rubbing noise. Regular cleaning or greasing of the bearings can help prevent this. If wear becomes too much, it is time to replace the bearings.

SPECIFICATION

Range, max speed and hill grade are all based on a 75kg(165lb) person riding at 12kmh/8mph on flat smooth terrain.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>