FiiK V3 Electric Skateboards Instruction Manual

Table of Contents

BATTERY

REAR HUB MOTOR

If the urethane on the rear hub motor wears down to less than 2mm thick, it is time to replace the outer urethane sleeve.

WHEEL BEARINGS

If excess water or dirt gets into the wheel bearings, they can start to make a grinding or rubbing noise.
Regular cleaning or greasing of the bearings can help prevent this.
If wear becomes too much, it is time to replace the bearings.

BUSHES

After some time, the bushes can age and start to go hard.
This can impact on the steering and performance of the board. When this occurs, it is time to replace the bushes.

ITEMS SPECIFICATIONS

Range, max speed, and hill grade are all based on a 50kg person riding at 10 km/h on flat smooth terrain.

FUTURE IS IN KNOWLEDGE

Please take note of the below safety information before riding your skateboard.

Always wear your helmet, knee pads, elbow pads, and wrist guards along with appropriate flat-soled shoes in case of an accident.
This board is recommended for users over the age of 10.
Observe all traffic rules and regulations and be aware of local laws on the use of electric skateboards.
Do not ride at night
Always ride within the limits of your capability and build up from the slow speed settings first.
Do not charge the board in abnormally hot, cold, or wet conditions.
Do not charge your board in a location that could be ignored or forgotten.
Do not ride the board in wet conditions as this can cause electrical components to short circuit and will not be covered by warranty.

SKATEBOARD

CHARGING

The Mini Fiik has a USB port located on the side of the CPU/battery box for charging mobile phones.
Do not use this charge port when riding the skateboard.
Ensure the Mini Fiik is fully charged before use
To charge, plug the charger into the wall socket and turn it on. This should show a green light on the charger.
Plug the charger into the skateboard’s charge port located on the side of the CPU/battery box. The light will turn red to indicate charging.
Once the board is fully charged the light will turn green. Unplug the charger once charging is complete
Only use the supplied charger to charge this board. An incorrect charger can damage the battery
If the board is unused for an extended period, please top up the charge every month to protect the battery.

If your board has lost connection with the remote, or you have had to replace the remote, you will need to repair it with the board.

Ensure the board and remote are both switched off.
Switch to SLOW (turtle) mode
Set the direction switch on the left side of the remote to “Backward”
Insert the supplied pin clip into the Binding hole until you feel it press a button. Turn on the power switch while still holding the binding button until the light starts flashing red/green/blue in sequence
Hold full brake on the remote and turn the remote on while keeping the brake on. Keep holding until the board light starts flashing green
The remote and board are now paired.

Turn the remote power switch into the on position
Press the power button on the board
The power indicator lights on the board will start flashing when the remote is connected
Check the remote is set to the correct speed that suits your capabilities
Before riding, ensure you have a good posture and a balanced center of gravity
To accelerate, slowly push the acceleration/brake lever forward in the “speed up” direction. The throttle is proportionally controlled, so the further you move the lever, the faster the board will go.
To brake, pull the acceleration/brake lever back in the “brake direction”. The brake is proportionally controlled, so the further you move the lever, the more brake you will apply.