Fiik Skateboards Australia Mini FiiK V1 Fiik Drifter Owner’s Manual

: September 7, 2024
: Fiik Skateboards Australia

Table of Contents

Fiik Skateboards Australia Mini FiiK V1 Fiik Drifter
INTRODUCTION
UNPACKING THE FIIK DRIFTER
ASSEMBLE GUIDE
SPECIFICATIONS
SAFETY & COMPLIANCE
FAQ
RETURN & WARRANTY
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Fiik Skateboards Australia Mini FiiK V1 Fiik Drifter

INTRODUCTION

WELCOME

The Fiik Drifter is the first of its kind, it is the only rear wheel drive electric drift trike on the market The Fiik Drifter is able to drift not only downhill like the original drift trikes but can also drift on flat ground and even up hill at speeds of up to 28 mph The Fiik Drifter also comes with a set of our purpose built drift sleeves, we have the only sleeves on the market that are molded to fit the average front go kart wheel.

UNPACKING THE FIIK DRIFTER

Please check carefully that all items are included in the Fiik drifter Box

1 x Fully Alloy front Frame (handle bars attached)
1 x Fully Alloy rear Frame (wheels attached)
1 x 11 Ah Lithium battery
1 x Lithium Battery Fast Charger
1 x Seat
2 x Parts Bag Bolts and tools required
1 x Owner’s Manual

Please check your new Fiik Drifter is free of any damage that might have been caused in transit If any damage is noticeable, do not ride the Drifter Contact your place of purchase immediately within 3 days or your claim may be refused ..(To substantiate your claim please take photos and write a description of the damage in question)
We highly recommend you immediately give the FiiK Drifter battery a full charge before your first ride

Plug the charger into your wall outlet and connect it to the charging jack on the side of the battery pack The light on the charger will be RED That means the battery is on charge Once the battery reaches full charge, the light turns GREEN
Charging time may vary DO NOT store for more than 60 days without charging
DO NOT RIDE THE FIIK DRIFTER WITH OUT FIRSTLY CHECKING YOUR TIRES TO ENSURE THEY ARE AT THE RECOMMENDED PRESSURE AS VALVE DAMAGE MAY OCCUR THIS DAMAGE IS NOT COVERED BY WARRANTY.
Tire pressure on Fiik Drifter should be set at 20 30 psi These recommended pressures have been set to give optimum control and battery performance Get into a habit of checking tire pressure regularly Low tire pressure can put undue stress on your motors and drive train

If you damage your tires or inner tubes please contact us to purchase replacements.

ASSEMBLE GUIDE

Before We Begin, Get the Tools supplied in the box.

Attach the handlebar on the front frame
Put the metal plate in the seat base and feed the wires which are in the front frame through the seat base
Attach the front frame through the seat base
Feed the wires through the rear frame and attach the front frame into the rear frame ..(Keep the 2 plastic sleeves in the rear frame
Bolt these two frames up with screws and nuts ..(Two washers, one on top and one underneath
Connect wires to the motor’s wires
Assemble the front wheel with the disparate right ..(The disc brake has to go in the middle of the brake on the front fork
Put the two black alloy pads on and bolt up with the black pegs
Check the pressure of the tires
Make sure the battery is fully charged up before you riding

Scan the QR code to watch the FiiK Drifter assembling video

SPECIFICATIONS

Frame Fully Alloy Frame
Motor 2 x 1000 Watt High Torque Brushless Motors
Top speed 28 mph*
Battery 11 Ah Lithium Battery
Charger AC 110 240 V
Range 20 kilometers 12 miles
Wheel 10 x 5 inch GoKart Wheels
Sleeves Purpose built Drift Sleeves
Controls Color LCD Panel
Brakes Hybrid Front Disc Brake
Package Dimensions
- Weight 40 kg
- Length 120 cm
- Width 75 cm
- Height 50 cm

*Depending on load, terrain, gradient and other factors

Note: Road and traffic rules may differ from state to state Check with your relevant traffic authority to avoid breaking the rules

Electrical and electronic equipment, batteries, accumulators and packaging material should not be disposed of with household waste
Please recycle where facilities exist Check with your Local Authority for recycling advice.

SAFETY & COMPLIANCE

WARNING: RISK OF DEATH OR SERIOUS INJURY
Whenever you ride a Fiik Drifter, you risk death or serious injury from loss of control, loss of braking power, collisions, and falls. To ride safely, you must read and follow all warnings and instructions in this manual.

By choosing to ride a Fiik Drifter, you assume the responsibility for that risk. It’s important that you understand and practice the rules of safe and responsible riding and proper use and maintenance to reduce the risk of injury or death.
Many local governments legislate “road worthy” laws and require specific safety equipment. It is your responsibility to familiarize and comply with all applicable laws of the location where you ride your Fiik Drifter.

Warning:

ALWAYS wear a helmet and protective gear such as knee pads, elbow pads, wrist pads and a padded jacket when riding.

Warning:

DO NOT ride the Fiik Drifter if you are under the influence of alcohol or drugs.
DO NOT ride the Fiik Drifter if you are under the age of 16 years old.
ADULT SUPERVISION IS REQUIRED!

Warning:

Avoid Water! Do not ride on wet or icy pavement. Any amount of water has the potential to damage the Fiik Drifters’ electronics, and water damage is not covered under warranty. Riding on wet or icy pavement is extremely dangerous due to the potential for losing traction and control.

Warning:

Pinch Points Keep fingers, hair, and clothing away from belts, motors, wheels, and all moving parts.

Warning:

Risk of Electric Shock Do not open or tamper with electronics housings which also voids the warranty

FAQ

Q: What should I do if I notice damage to my Fiik Drifter upon unpacking?
- A: Contact your place of purchase immediately with photos and a description of the damage within 3 days to avoid claim refusal.
Q: What is the recommended tire pressure for the Fiik Drifter?
- A: The recommended tire pressure is between 20-30psi for optimal control and battery performance.
Q: How should I dispose of electrical and electronic equipment, batteries, accumulators, and packaging material?
- A: Do not dispose of them with household waste. Please recycle where facilities exist. Check with your Local Authority for recycling advice.

RETURN & WARRANTY

Returning Products within 30 Days of Purchase:

If you are not satisfied with the Product(s) that you purchased through our Website, you may return the Product(s) within thirty (30) days from the date that we deliver the applicable Product(s) for a full refund less a 15% restocking fee, as further described in this paragraph. We will provide a refund for the cost of the Product(s) not including any shipping charges within thirty (30) days of our email to you confirming your refund. The product(s) must not be abused, damaged and must be in original packaging as determined in our sole discretion. Please send an email to support@fiik.com before sending any product(s) back to us to obtain a return authorization number . Any product(s) returned to us without an authorization number it will be returned to the owner at the owner’s expense.

Returning Products for Warranty Claims:

Your Products (whether purchased on the Website or through an authorized retailer) are warranted against defects in materials and workmanship for a period of six (6) months from the date of original retail purchase (if purchased at a retailer), or six (6) months from the date of shipment (if purchased on the Website), or other period if the Company expressly notifies you in writing (“Warranty Period”) in each case only when used in accordance with the applicable usage documentation.

If a defect arises during the Warranty Period, Company will, at its option, (1) repair the affected Products at no charge using new parts or parts that are equivalent to new in performance and reliability, (2) exchange the affected Products with functionally equivalent Products that are new or formed from new and/or previously used parts that are equivalent to new in performance and reliability or, with your consent, Products that are at least functionally equivalent to the Products it replaces; or (3) refund the original purchase price for the affected Products. This warranty excludes normal depletion of consumable parts unless failure has occurred due to a defect in materials or workmanship, and damage resulting from abuse, accident, modifications, unauthorized repairs, neglect, abuse, water damage, impact damage, dropping, punctures, exceeding excess designed weight loads, damage caused because of tricks such as getting air, ramp jumps, grinding of axles or underneath components or other causes that are not defects in materials and workmanship. No other person is authorized to modify this limited warranty.