Razor W25141001039 Ground Force Rad Rod Instruction Manual

Razor W25141001039 Ground Force Rad Rod

Product Information

Specifications:

• Model: GROUND FORCE RAD ROD
• Part Number: W25141001039
• Tools Required (Not included):

1. 5 mm Allen wrench
2. Phillips screwdriver
3. 10 mm open-end wrench

Product Usage Instructions

• Step 1:
  Use a 5 mm Allen wrench to remove the screw and washer on the top of the steering wheel.

• Step 2:
  Use a 5 mm Allen wrench to remove two (2) screws below the steering wheel.

• Step 3:
  Use a Phillips screwdriver to remove five (5) screws on the rear battery cover.

• Step 4:
  Use a Phillips screwdriver to remove three (3) screws on the front battery cover.

• Step 5:
  Unplug all the connectors between the steering wheel and the controller.

• Step 6:
  Use a 10 mm open-end wrench to loosen the nut on the brake. Pull out brake line.

• Step 7:
  To install a new steering wheel, reverse steps 1-6. Charge battery for 8 hours before using.

Frequently Asked Questions (FAQ)

What should I do if I encounter difficulties during the replacement process?
For assistance, visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.

Required Tools: (Not included)

• A. 5 mm Allen wrench
• B. Phillips screwdriver
• C. 10 mm open-end wrench

WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

ASSEMBLY INSTRUCTION

• Step 1
  Use a 5 mm Allen wrench to remove the screw and washer on the top of the steering wheel.

• Step 2
  Use a 5 mm Allen wrench to remove two (2) screws below the steering wheel.

• Step 3
  Use a Phillips screwdriver to remove five (5) screws on the rear battery cover.

• Step 4
  Use a Phillips screwdriver to remove three (3) screws on the front battery cover.

• Step 5
  Unplug all the connectors between the steering wheel and the controller.

• Step 6
  Use a 10 mm open-end wrench to loosen the nut on the brake. Pull out brake line.

• Step 7
  To install a new steering wheel, reverse steps 1-6.
  ATTENTION: Charge battery 8 hours before using.

Need Help?
Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.

References

• Razor | Scooters and Ride-ons for the whole family

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>