Razor W25141001002 Ground Force Rad Rod Electric Powered Ride Instruction Manual

: August 29, 2024
: Razor

Table of Contents

Razor W25141001002 Ground Force Rad Rod Electric Powered Ride
Product Information
Product Usage Instructions
Frequently Asked Questions (FAQ)
Required Tools: (Not included)
ASSEMBLY INSTRUCTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Razor W25141001002 Ground Force Rad Rod Electric Powered Ride

Product Information

Specifications:

Model: GROUND FORCE RAD ROD REAR AXLE REPLACEMENT
Part Number: W25141001002
Required Tools (Not included):

1. 5 mm Allen Wrench
2. 3 mm Allen Wrench
3. Phillips Screwdriver
4. Long Needle Pliers
5. Two (2) 17 mm Socket Wrenches
6. 10 mm Open-End Wrench
7. C Clip Pliers

Product Usage Instructions

Step 1: Remove the Seat
Use a 5 mm Allen wrench to remove four (4) screws on the seat, then remove the seat.
Step 2: Remove Battery Rear Cover
Use a Phillips screwdriver to remove five (5) screws on the battery rear cover.
Step 12: Remove the Rear Axle
Remove the rear axle from the frame.
Step 13: Install New Rear Axle
To install a new rear axle, reverse steps 1 through 12. Charge battery for 8 hours before using.

Frequently Asked Questions (FAQ)

Where can I find more help or support?
Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.

Required Tools: (Not included)

A. 5 mm Allen Wrench
B. 3 mm Allen Wrench
C. Phillips Screwdriver
D. Long Needle Pliers
E. Two (2) 17 mm Socket Wrenches
F. 10 mm Open-End Wrench
G. C Clip Pliers

WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

ASSEMBLY INSTRUCTION

Step 1
Remove the flag and use a 5 mm Allen wrench to remove four (4) screws on the seat, then remove the seat.
Step 2
Use a Phillips screwdriver to remove five (5) screws on the battery rear cover.
Step 3
Use a Phillips screwdriver to remove three (3) screws on the battery front cover. Then remove the battery front cover after unplugging all plugs.
Step 4
Using a Phillips screwdriver, remove the screws from the chain cover and remove the cover.
Step 5
Using two (2) 17 mm Socket wrenches, loosen and remove the lock nuts from the rear wheels.
Step 6
Remove the wheels and hardware from the axle and set aside.
Step 7
Use a 5 mm Allen wrench and a 10 mm open-end wrench to remove two (2) bolts and lock nuts from the brake drum.
Step 8
Use a 3 mm Allen wrench to remove the set screw on the brake hub. Slide the brake drum and brake hub off from the axle.
Step 9
Using long needle pliers, remove the master link from the chain and remove the chain.
Step 10
Use a 3 mm Allen wrench to remove the set screw from the sprocket and slide it out from the axle.
Step 11
Use C clip pliers to take off the snap rings on both sides.
Step 12
Remove the rear axle from the frame.
Step 13
To install a new rear axle, reverse steps 1 through 12.
ATTENTION: Charge battery 8 hours before using.