dormakaba SL30 SGL Electronic Side Load Lock User Guide

: August 27, 2024
: dormakaba

Table of Contents

dormakaba SL30 SGL Electronic Side Load Lock
Wiring
Warranty Information
Package Contents
Product Dimensions
Operating Mode
FAQs
CONTACT INFORMATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

dormakaba SL30 SGL Electronic Side Load Lock

Wiring

Wiring the lock requires at least three connections; red (positive), black (negative), and blue (control).
Ensure the power supply has the following current available to power the lock when supplied with the following; 400mA for 24VDC supply and 750mA for 12VDC supply.
Use an appropriate wire gauge for the wire run distance between the lock and the power supply.
Do not mount the lock on the floor operating upwards or in an environment where it can get wet

Warranty Information

The product is covered by a 3-year manufacturer’s warranty against faulty or malfunctioning parts, components, or products.
A faulty product can be returned at the customer’s expense to the seller for review.
At the seller’s discretion, either a replacement lock or an affected part will be supplied to remedy the fault.
Removing the lock cover or faceplate screws may void the warranty. Mistreatment or ill-use of the lock may void the warranty.

Package Contents

Product Dimensions

Dimensions are provided in the form of a diagram showing various measurements:

Overall length: 204mm
Width: 25mm
Depth: 42mm
Mounting hole spacing: 184mm
Strike plate dimensions: 124mm x 32mm

Wiring Gauge Table

Wiring IO Table

Operating Mode

How to wire the lock for each operating mode

Fail-Safe Wiring, control high to lock.
Fail Secure Wiring, control low to lock.

How to set the operating mode

Toggle the switch on the product before powering it up

Wooden Door Frame Mortice Example SL30 SGL

The dimensioned drawing is an example of how to cut the mortice for the lock into a timber door frame. This should be centered with the center of the door leaf when closed.
Cut any additional pathways required for the wiring loom.
Ensure the lock is orientated such that the bolt pin pulls the door in towards the door jamb.
Pull wiring through and connect to the lock, then fit the lock into the mortice and secure with included mounting screws.
Repeat process for strike plate allowing room behind bolt pin hole.
Alternative mounting options are available for metal and glass. Refer to the installation and operating instructions for accessories and alternative mounting procedures.

FAQs

What is the warranty period for the SL30 SGL?

The product is covered by a 3-year manufacturer's warranty against faulty or malfunctioning parts, components, or products.

How do I wire the SL30 SGL lock?

The lock requires at least three connections: red (positive), black (negative), and blue (control). Ensure the power supply has the required current available to power the lock (400mA for 24VDC supply and 750mA for 12VDC supply). Use an appropriate wire gauge for the wire run distance between the lock and the power supply.

What are the dimensions for the mortice cutout in a wooden door frame?

The dimensioned drawing provides specific measurements for cutting the mortice in a timber door frame. Ensure the cut is centered with the center of the door leaf when closed.

How do I set the operating mode of the SL30 SGL lock?

Toggle the switch on the product before powering up to set the operating mode to either Fail Safe or Fail Secure.