SAM S CAN Series Defender Automatic Reverse Light Kit Installation Guide

August 26, 2024
SAM S

SAM S CAN Series Defender Automatic Reverse Light Kit

Product Information

Specifications

  • Product Name: CAN-AM Defender Backup Beeper Kit
  • Required Tools:
    • Torx T-30
    • 10mm Wrench/Socket
    • Philips Screwdriver/Bit

Product Usage Instructions

Step 1: Secure and Plug-in Controller

  1. Remove diagnostic connector and plug connector into the controller.
  2. Secure fuse and relay with the provided mounting screw.

Step 2: Plug-In and Secure Backup Beeper

  1. Secure the backup beeper using the preexisting T-30 bolt.
  2. Plug the backup beeper into Sam’s Backup Lights harness.

Frequently Asked Questions (FAQ)

  • Q: Can I install the backup beeper kit without professional help?
    A: While it is possible to install the kit following the provided instructions, it is recommended to seek professional help for proper installation to avoid any damage.

  • Q: Are there any specific maintenance requirements for the backup beeper?
    A: The backup beeper does not require regular maintenance. Ensure all connections are secure and functioning properly.

WHAT’S INCLUDE

Description Quantity
Wiring Harness 1
Backup Beeper 1
Relay 1
Controller 1
Mounting Screws 3

Required Tools:

Torx T-30

10mm Wrench/Socket
Philips Screwdriver/Bit

OVERVIEW

INSTALLATION INSTRUCTION

Step 1: Secure and Plug- in Controller

  1. Remove diagnostic connector and plug connector into controller.
    Note: Refer to page 5 for explanation of diagnostic connector assembly.

  2. Secure controller with provided mounting screws; if necessary, drill 1/16” pilot hole.

  3. Secure fuse and relay with provided mounting screw.

Step 2: Plug – In and Secure Backup Beeper

  1. Secure backup beeper using preexisting T-30 bolt.
  2. Plug the backup beeper into the Sam’s Backup Lights harness.

Step 3: Attach Leads

  1. Remove nut from red terminal under hood with 10mm wrench & secure red ring terminal.
  2. Repeat process for black ring terminal.

Factory Can-Am Diagnostic Connector

The Orange wire from Sam’s Controller needs to match the Orange/Green wire on the factory Can-Am diagnostic connector

Operation of Reverse Lights

Sam’s Backup Lights are automatic. NO switches or programming required. When the vehicle is shifted into reverse, the backup beeper will automatically come on.

Note: If the ignition is turned off while the vehicle is in reverse the backup beeper will remain ON until the ECU enters sleep mode (approximately 30 secs to 2 minutes depending on vehicle and ECU type).

Sam’s Backup Lights
www.samsbackuplights.com
CAN-AM Defender Backup Beeper
support@samsbackuplights.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals