Natures Composites Composite Gardening Square Planter Installation Guide
- August 26, 2024
- Natures Composites
Table of Contents
Natures Composites Composite Gardening Square Planter Installation Guide
COMPONENTS
- A. Left Hand Leg (Qty 2)
- B. Right Hand Leg (Qty 2)
- C. Tie Beam (Qty 2)
- D. Cross Beam (Qty 2)
- E. 1″ Screws (Qty 16)
- F. Large T&G Board (Qty 6)
- G. Medium T&G Board (Qty 3) (Qty 6 for 2×4)
- H. Short T&G Board (Qty 6)
- I. Top Cap (Qty 4)
- J. ¾” Screws (Qty 12)
Tools Required: Philips Head #2 Screwdriver
ASSEMBLE SIDE WALLS
- 1. Lay one LH Leg (A) and one RH Leg (B) down on a smooth, flat surface
- 2. Choose bed depth (6″, 8″, 10″)
- 3. Fasten the Tie Beam (C) to the legs at desired bed depth using 1″ Screws (E) on each leg, ensure the open joint it point up (See below)
- 4. Repeat steps for the remaining legs
INSTALL CROSS BEAMS
- 5. Carefully stand-up the side walls
- 6. Space the side walls 20.25″ apart as shown
- 7. Slide the Cross Beams (D) into the slots of the Tie Beam (C) until they meet
- 8. Fasten the end Cross Beams (D) into the legs using 1″ Screws (E)
INSTALL SIDE WALL BOARDS
- 9. Install three Large T&G Boards (F) into the groove of the side wall
- 10. Repeat steps for the other side wall
INSTALL SHORT BOARDS
- 11. Slide three Short T&G Boards (H) into the U-channel grooves on the left side
- 12. Install remaining three on the right side
INSTALL BASE BOARDS
- 13. Lay three (six for 2×4 box) Medium T&G Boards (G) on the base with the tongue side first.
- 14. Evenly space the boards within base keep the boards locked together.
INSTALL TOP CAP
- 15. Slide four Double Top Caps (I) on to the top of each post
- 16. Secure with three 3/4″ Screws (J) on each cap using the pilot holes.
To Fill Planter: Fill Planter with lightweight potting soil mix, avoid using heavy soil mixtures that contain clay, sand andor gravel. Drill ¼” holes in base boards for additional drainage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>