Razor W25141001106 Ground Force Rad Rod Instruction Manual
- August 21, 2024
- Razor
Table of Contents
GROUND FORCE RAD ROD CHARGER PORT
REPLACEMENT INSTRUCTIONS
PART # W25141001106
W25141001106 Ground Force Rad Rod
Required Tools: (Not included)
A Phillips screwdriver
B. Flat screwdriver
C. Long needle pliers
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF
and disconnect charger before conducting any assembly or maintenance
procedures. Failure to follow these steps in the correct order may cause
irreparable damage.
Step 1
Use a Phillips screwdriver to remove five (5) screws on the battery rear
cover.
Step 2
Use a Phillips screwdriver to remove three (3) screws on the battery front
cover.
Step 3
Unplug the connector between the charging port and power switch. Using a flat
screwdriver, remove the glue on the back of the charger port. Using long
needle pliers, remove the lock nut that holds the charger port in place.
Step 4
To install a new charging port, reverse steps 1-3.
When reconnecting the charger port, make sure to connect it only on the gold
colored prong from the power switch.
ATTENTION: Charge battery 8 hours before using.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>