EUROfase 48118 TRIAS Wall Mirror Instruction Manual

EUROfase 48118 TRIAS Wall Mirror

Product Information

Specifications

• Model: TRIAS 48118
• Power: 52W MAX, LED, 120V~, 60Hz

Product Usage Instructions

Installation

1. Ensure the power source is switched off before installation.
2. Mount the lighting product securely using the provided hardware and following the manufacturer’s guidelines.
3. Connect the product to the power supply as instructed in the manual.

Operation

1. Turn on the power supply after installation is complete.
2. Use the designated switches or controls to operate the lighting product.
3. Adjust the settings as needed to achieve the desired lighting effect.

FAQ (Frequently Asked Questions)

• Q: What should I do if the light does not turn on?
  A: Check the power source and connections to ensure everything is properly set up. If issues persist, contact Customer Service for assistance.

• Q: Can this product be used outdoors?
  A: This product is designed for indoor use only. Using it outdoors may result in damage to the product.

• Q: How do I adjust the brightness of the light?
  A: Refer to the product manual for specific instructions on adjusting brightness levels, as it may vary depending on the model.

Thank You
You’ve just purchased a lighting product designed and built to provide you with years of enjoyment.

IMPORTANT SAFETY INSTRUCTIONS

• Attention to installer, must test the light fixture before installation.
• When using an electrical furnishing, basic precautions should always be followed, including the following:
• Read all instructions before using (this furnishing).
• DANGER – To reduce the risk of electric shock: Always unplug this furnishing from the electrical outlet before cleaning or servicing.
• WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
• Unplug from outlet before putting on or taking off parts.
• Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
• Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
• Never operate this fumishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
• Keep the cord away from heated surfaces.
• Never operate the fumishing with the air openings blocked. Keep the air openings free of lint, hair, and the like.
• Never drop or insert any object into any opening.
• Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
• To disconnect, turn all controls to the off position, then remove plug from outlet.
• WARNING: Risk of Injury – Keep children away from this furnishing.
• WARNING: Risk of Electric Shock – Connect this furnishing to a properly grounded outlet only. See Grounding Instructions.
• GROUNDING INSTRUCTIONS:
  • For a permanently connected product: This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the product.
  • For a grounded, cord-connected product rated max 15 amperes and intended for use on a nominal 120-volt supply circuit :
  • This product is for use on a nominal 120-volt circuit and has a grounding plug. Make sure that the product is connected to an outlet having the same configuration as the plug. No adapter should be used with this product.
• For loading always put heavier items at the bottom and not near the top in order to help prevent the possibility of the furnishing tipping over.
• WARNING: Risk of Injury to Persons – do not use this furnishing to support video equipment such as televisions or computer monitors.
• Mount furnishings at the correct height.
• This unit is suitable for installation in a damp, indoor location only.
• This unit is to be mounted to a metal electrical junction box (outlet box) directly supported by the building structure.
• Save this instructions for future reference.
• Estimated Assembly Time: 20 minutes

HARDWARE INCLUDED

Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder.

VERTICAL MOUNTING

Temporarily secure the paper (G) to the wall, then mark the anchor (D) locations on the wall through the holes. Remove the paper (G) and drill holes making them slightly smaller than the anchors (D) provided.

OPERATION INSTRUCTIONS

• Short touch: ON and OFF
  Press and hold: Dimmable

• Short touch to turn ON and OFF for the defogger function. Automatic turn off after 1 hour.

• Short touch to adjust the colour temperature: 3000K (Warm), 4500K (Neutral), 6400K (Cool).
  Press and hold: Stepless CCT.

Customer Service & Tech Support: 905-695-2147
Email: Info@eurofase.com
33 West Beaver Creek Rd, Richmond Hill, Ontario Canada L4B 1L8

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>