LINDY 50m USB 1.1 Cat.5 Extender User Manual
- June 3, 2024
- LINDY
Table of Contents
LINDY 50m USB 1.1 Cat.5 Extender
Introduction
Thank you for purchasing this Cat.5 USB Extender. This product has been
designed to provide trouble free, reliable operation. It benefits from both a
Lindy 2 year warranty and free lifetime technical support. To ensure correct
use, please read this manual carefully and retain it for future reference.
This USB Extender can be used to extend the distance between a USB device and
a host computer by up to 50m. It consists of a local unit with USB Type A
connector (host computer side) and a remote unit (device side) with built in
USB Type A female connector. A standard Cat. 5 network cable (UTP or STP) up
to 50m length is used to connect the two units (not included)
For certain USB Low Speed devices like USB mice it may be possible to extend
the distance even further to 100m. This will depend very much on the device
connected, as this extended distance may not be guaranteed. In most cases USB
1.1 Full Speed data transfer (12Mbps) will not work over extended distances
but is guaranteed to work up to 50m.
Package Contents
- Transmitter unit
- Receiver Unit
- This manual
Features
- USB Interface: USB 1.1
- Interconnect UTP/STP cable length up to 50m
- Equivalent Hub Delay/Count: 20m 2 Hubs
30m 3 Hubs
50m 5 Hubs
Please note:
- The maximum number of hubs in any USB connection from host to device cannot be more than 5 including any USB hubs or Active Extension cables or the equivalent hub rating of this USB Extender. Therefore, when using a 50m UTP/STP cable no extra hubs or extension cables can be used between computer and device.
- When using a high current USB device such as a modem, camera etc. with the USB Extender you must connect the power supply supplied with the device.
- The USB Extender does not support the USB 50µA maximum Suspend Mode current limit.
Technical Data
- Supply Current Drawn: ~20mA
- Operating Temperature: 0° – 70°C (32°F – 158°F)
- Storage Temperature: -20° – 80°C (-4°F – 176°F)
Caution: This unit does not fully meet all USB specifications and as such does not register with the USB bus. It is capable of extending the maximum distance of 5m imposed by USB by one USB segment only. Please consider these limitations, otherwise the USB bus may not function correctly. It should also be connected to an exclusive USB port on your computer.
Recycling Information
WEEE (Waste of Electrical and Electronic Equipment), Recycling of
Electronic Products
In 2006 the European Union introduced regulations (WEEE) for the collection
and recycling of all waste electrical and electronic equipment. It is no
longer allowable to simply throw away electrical and electronic equipment.
Instead, these products must enter the recycling process. Each individual EU
member state, as well as the UK, has implemented the WEEE regulations into
national law in slightly different ways. Please follow your national law when
you want to dispose of any electrical or electronic products. More details can
be obtained from your national WEEE recycling agency.
CE/FCC Statement
CE Certification
LINDY declares that this equipment complies with relevant European CE
requirements.
Manufacturer (UK):
LINDY Electronics Ltd
Sadler Forster Way
Stockton-on-Tees, TS17 9JY
England
sales@lindy.co.uk
T: +44 (0)1642 754000
Tested to comply with FCC standards.
For home and office use.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>