SEAJIC ST30 One TouchDeploy Selfie Stick Tripod User Manual
- August 16, 2024
- SEAJIC
Table of Contents
One-TouchDeploy
Selfie Stick Tripod
Model:ST30
[Disruptive patented product, automatic bouncing upon landing]
User Manual
Connect Bluetooth to mobile phone
- Fix the mobile phone onto the holder, press and hold the camera button for 3s until the green lamp flickers, to enter the Bluetooth pairing mode;
- Enter Bluetooth settings of mobile phone, to search and connect “SEAJIC MT2”; the green indicator will be normally on after successful connection;
- Press the camera button on the product to take photos; press and hold the camera button for 3s to power off the product and disable Bluetooth pairing mode.
Attention: The product will connect the successfully paired mobile phone by default. To connect a new mobile phone, you need to unpair the former mobile phone before pairing a new one。
Product Introduction
Unfold/fold tripod
First of all, pull the handle of the mobile phone holder out along upward direction and drop it vertically from a height of about 10cm from the ground; then the tripod of selfie stick will bounce automatically。
While folding the product, hold the middle position of tripod, and push back the pull rod back to the handle sleeve section by section。
Fixing holder of mobile phone
Put the mobile phone horizontally onto the holder at 45°, and push it upwards gently to fix the mobile phone onto the holder。
Switch between horizontal and vertical screen
The product is fitted with a patented slide-rail holder and a space for
forward/backward tilt and left/right rotation. The horizontal and vertical
screen can be switched freely without removing the mobile phone.
Charging of remote control
Please recharge the remote control of the holder using USB cable。If the remote control has a low capacity during use, the indicator lamp will flicker in red。The indicator lamp is normally on in red during recharging and is off after recharging is finished。
The remote control is absorbed by the magnet and taken Oute When putting it back, align it at the slot and adsorb automatically.
Specification & parameters
Model: ST30
Overall dimensions: 3324839mm
Weight: 420g
Connection mode: Bluetooth
Distance of remote control: 10m
Supported system: Android/IOS
Materials: ABS+PC/aluminum
Battery capacity: 50mAh
Type-C input: 5V/100mA
Important safety information
- Please read all safety and operation instructions carefully before using the product. Keep the manual properly for further use;
- Please pay attention to all precautions on the product and in the Manual;
- Please follow all operation and use instructions;
- Use the accessories/attachments designated by the manufacturer only;
- The product must be maintained by professionals;
- For any damage of the product, such as holder damage, liquid penetration, affection by rainwater or moisture, functioning failure or damage due to falling, please contact the official after-sales service specialist to receive the designated maintenance service。
Name and content of hazardous substances in the product
Name and content of toxic and hazardous substances or elements in the product
Parts|
---|---
Pb Lead| Hg Mercury| Cd Cadmium| Cr(VI) Hexavalent
Chromium| PBBs Polybrominated
piphenyls| PBDEs Polybrominated
diphenyl ethers
Selfie stick| 0| 0| 0| 0| 0| 0
Packing accessories| 0| 0| 0| 0| 0| 0
This table was prepared according to SJ/T11364
: It means that the content of the toxic and hazardous substance in all the
homogeneous materials of the component is below the limit requirements
specified in GB/T 26572.
Ｘ: It means that the content of the toxic and harmful substance in at least
one homogeneous material of the component exceeds the limit requirements
specified by GB/T 26572.
To protect the environment and human health:
- Once scrapped, the product should be separated from the household wastes; users have responsibilities for sending the scrapped products to the designated recycling center;
- The recycling center should recycle the product’s useful materials properly;
- For details of scrapping the product, please consult the local government, waste disposal center or dealer;
The product’s environmentally friendly service life, which is 10 years, is determined by the enterprise according to its design characteristics. The product’s environmentally friendly service life is effective only when the product is used under the normal conditions mentioned in the Manual。
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
After-sales services of SEAJIC
After-sales service commitment of SEAJIC: We provide three-warranty services
for all products which are sold through the official channel or authorized
channel of SEAJIC in strict accordance with Law of the People’s
Republic of China on Protection of Consumer Rights and Interests. For regions
where special three-warranty regulations are executed, SEAJIC hereby
undertakes to abide by the local regulations. Please keep the warranty card
and effective purchase voucher properly in order to safeguard your legal
rights.
Warranty Card of SEAJIC
User Information
Name:____
Contact phone:
Date of purchase:____
Purchase platform and shop name:_
Order No.:___
Product information:__
Model:__
OSM (China) owns the right of interpretation of pictures and texts in the Manual。
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>